DIY Projects Using Church Pews

Written by heather warren
  • Share
  • Tweet
  • Share
  • Pin
  • Email
DIY Projects Using Church Pews
Church pews are often lovely pieces of furniture that can be reused for a multitude of purposes. (church pew image by palms from

Church pews, while once thought as of stuffy and uncomfortable, can be turned into very useful and attractive pieces of furniture with a little imagination and creativity. Pews can also appeal to frugal budgets. Many show up at garage sales or in used furniture stores, meaning you don't have to break the bank to spruce up your home.

Other People Are Reading

Church Pew Headboard

Leave the casters (wheels) on the pew if they are some already in place. This saves a step in the process of converting the pew. Decide whether you would like to go rustic and leave the pew "as is" or give it a paint job to spruce it up. If you decide on paint, allow it to dry for 24 hours before proceeding with plans.

Place your bed in the middle of the pew (or if you're working in a shop or garage, use the measurements of your bed). Measure how much room is left on either side of the pew. Mark off the points where your bedside stops and your "end table" will fit snugly against the sides. Cut out the seat in the middle, up to the lines you've just made. Drill holes at the bottom ends of the pew and attach it to your bed frame with nuts and bolts.

Antique Bench

Turn an old church pew into a antique bench for an entryway or sitting room. Depending on the age of the pew, antiquing may not even be necessary. Paint the pew an off-white colour, let dry, and then add some dings and scrapes with a hammer. Use sandpaper to blend away the paint on areas that would normally wear away over time. Start with areas such as arm rails, the backs of seats and the legs of the pew. Blend in the rest of the areas lightly. Use light brown wood stain to create an aged effect. Apply with a paint brush, using a light hand. Let the stain drip into dings and cracks. Let dry and position as you wish.

Porch Swing

Convert an old church pew with arm rests into a porch swing. Take steps such as adding outdoor cushions to add new life to an old relic. Refinishing may be necessary depending on the shape of the pew, but there is always the option of going with a "shabby chic" look. Screw in heavy duty "D-rings" at each back corner and in the centre of each arm rest. Using carabiners, attach a length of chain to each back D-ring that will extend 8 inches beyond the swing support system when the pew is at the ideal height. Connect a short piece of chain from each arm rest to the back chains 6 inches above the back D-rings using climber clips. Attach the back chains to an existing porch swing support system with nuts and bolts.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.