How to Install a Globe 360 V2 Mod Chip on an XBox 360

Written by breann kanobi
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Install a Globe 360 V2 Mod Chip on an XBox 360
Remove screws with a screwdriver. (a screwdriver image by alri from Fotolia.com)

The Xbox 360 console only plays properly encrypted games and cannot play burnt games or DVDs. However, you can install a mod chip, such as the Globe 360 mod chip, to allow your Xbox to play burnt games or use other "homebrew" content. The version 2 Globe 360 mod chip is a "plug and play" chip and requires no soldering. Even though the Globe 360 mod chip is easier to use than many chips, it still requires careful precision.

Skill level:
Easy

Other People Are Reading

Things you need

  • Flathead screwdriver
  • Torx screwdriver

Show MoreHide

Instructions

  1. 1

    Detach the Xbox 360 cables from the TV and the electrical socket.

  2. 2

    Remove the faceplate. Place one hand on the inside of the USB port cover. Push inward and pull off the faceplate.

  3. 3

    Push the grey ventilation shield toward the ground. Look into the opening created by the empty ventilation shield. Locate the tabs that attach to the grey plastic clips. Remove the tabs by pulling them out of the Xbox 360.

  4. 4

    Place the console on a flat surface, upside down. Remove the clips that hold the top sheet and the bottom sheet together. Pry off the clips using a flathead screwdriver. Remove the top by pulling it off the Xbox 360.

  5. 5

    Remove the silver and black screws inside the console using a Torx screwdriver. You should remove 14 silver screws and 8 black screws.

  6. 6

    Life the console up while holding down on the outer shell. This should remove the console from the outer shell. Place the Xbox 360 on a flat surface, right-side up.

  1. 1

    Plug the header pins that came with the Globe 360 V2 modchip and insert them into the motherboard.

  2. 2

    Push the mod chip onto the pins. Line up the mod chip with the pin headers on the Xbox 360.

  3. 3

    Replace the screws of the Xbox 360 using the Torx screwdriver. Reassemble the Xbox 360.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.