How to make flare jeans bootcut

Written by camela bryan
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to make flare jeans bootcut
The width at the hem differs in flare and boot-cut jeans. (Image by Maegan Tintari; Flickr.)

There is no standard silhouette for any type of jeans. The cuts vary by brand. Most flare and boot-cut jeans taper to the knee and flare out below the knee. Flare jeans flare out a noticeable amount, perhaps as much as the bell-bottoms of the 1970s. Boot-cut jeans flare out just enough to accommodate the top of a boot. It is easy to change flare jeans to boot-cut, because you have to alter them only below the knee.

Skill level:
Easy

Other People Are Reading

Things you need

  • Seam ripper
  • Tailor's chalk
  • Ruler
  • Scissors
  • Heavy-duty sewing machine
  • Denim sewing machine needle
  • Heavy-duty thread
  • Iron

Show MoreHide

Instructions

  1. 1

    Rip out the hem of the jeans. Take out the side seams from the hem to 5 cm (2 inches) above the knee.

  2. 2

    Spread one leg of the jeans out on a flat surface with the seams on each side. Decide on the desired width of the jeans at the hem. This will be half the distance around the hem of the jeans. Add 3.75 cm (1 1/2 inches) to this width for seam allowances.

  3. 3

    Measure the current width of the fabric at the hem of the jeans. Subtract the new width you calculated. This is the amount of fabric you will be removing. Divide this number in half and mark this distance from the edge of the fabric on each side of the hem with chalk.

  4. 4

    Draw a line from the marks on the hem to the edge of the fabric at the knee, using chalk and a yard stick. Cut off the excess fabric, cutting through both layers of fabric. Use the pieces you cut off as a pattern to cut the other leg. Use the fabric you cut off the inside of the leg for the pattern on the inside of the other leg and the outside fabric piece on the outside.

  5. 5

    Turn the jeans wrong-side out. Sew the outside seams of the jeans with a 1.25 cm (1/2 inch) seam allowance. Use thread that matches the fabric. Finish the seam with a zigzag or over-lock stitch.

  6. 6

    Turn the jeans right-side out. Sew the inside seams of the jeans with the wrong sides together and a 2.5 cm (1 inch) seam allowance. Trim 1.25 cm (1/2 inch) off the seam allowance on the back side of the jeans. Press the seam allowance toward the cut seam.

  7. 7

    Fold the long side of the seam allowance over the short side and press the seam down. Stitch the folded seam down, close to the edge, with thread that matches the thread in the rest of the seam. This is a flat-felled seam.

  8. 8

    Replace the hem.

Tips and warnings

  • Start all side seams at the top and try to match them to the existing seams.
  • Your jeans may have flat-felled seams on the outside seams also. If so, add 5 cm (2 inches) for seam allowances and follow the instructions for sewing the inside seams.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.