DIY: Making Thread Cutting Oil for a Pipe

Written by tony oldhand
  • Share
  • Tweet
  • Share
  • Pin
  • Email
DIY: Making Thread Cutting Oil for a Pipe
Corn oil makes an excellent thread-cutting oil. (corn image by dinostock from

Making thread-cutting oil for a pipe is not that difficult; people have been doing it for years. Common household materials, which are readily available at any grocery or department store, have been proven to work effectively. In 1921 Mr. Edward K. Hammond researched this area extensively and, even back then, he recommended environmentally-friendly compounds. While these compounds are biodegradable, they are a very efficient lubricant for cutting threads on a pipe. There are two types, water-based and oil-based, and both work equally well.

Skill level:
Moderately Challenging

Other People Are Reading

Things you need

  • Soybean oil
  • Corn oil
  • Glycerine
  • Water
  • Lard
  • Paint brush
  • Wooden craft stick

Show MoreHide


  1. 1

    Fill your oil can with corn oil, soybean oil or a mixture of both. Apply liberally to your thread-cutting die as you are cutting the threads on a pipe. This will work equally well on all thread-cutting operations, such as when you are tapping a thread in a hole.

  2. 2

    Purchase glycerine in any grocery or department store. Glycerine is found in the feminine hygiene aisle, under the vaginal lubricants section. Dissolve the glycerine in water until it is the consistency of about 30-weight oil. Fill your oil can with the glycerine/water mix. Apply liberally to the threads as you are working the thread-cutting die.

  3. 3

    Open a can of lard, either vegetable- or animal-based. Apply the lard to the die with a stiff paint brush or a wooden craft stick as you are cutting the threads. Saturate the die/thread area thoroughly, and apply often.

Tips and warnings

  • Always apply liberally; it is better to have too much than not enough. Also, if you wish to reuse the oil, let the shavings settle out in your catch pan, then skim off and filter the oils.
  • The glycerine/water mix works best for machine cutting. Since machine cutting heats up the pipe more, the danger of the oil catching fire is present. If you are using oil-based lubricant, run the machine at its slowest speed. Also, keep a fire extinguisher handy in any machine shop, just in case.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.