Jupiter is the largest planet of our solar system and has 60 moons that we know of so far. Since many of Jupiter's satellites are so small in comparison of the planet, most models display only the four largest moons: Io, Europa, Ganymede and Calisto. These are known as the Galilean moons. Making a model of Jupiter is inexpensive, easy and a fun way to learn about the planet.
Things you need
12-inch diameter styrofoam ball
2-inch diameter styrofoam ball
2, 1-inch diameter styrofoam ball
½-inch diameter styrofoam ball
Craft paint brushes
12-inch square heavy cardboard
Thin wire, such as floral wire
Paint your 12-inch styrofoam ball with craft paint in the colours of white, various shades of brown and orange. Lighten the brown and orange paints with white paint so the shades vary. Don't forget to make the red swirl, Jupiter's famous storm, on the lower portion of the planet. Refer to a space photo of Jupiter to get the colouring correct. Paint the top half of the sphere first. Allow it to dry. Then turn it over to paint the bottom half. This will prevent smearing.
Paint the 2-inch diameter styrofoam ball to look like Io with yellow and brown mottled paint. Paint the 1-inch diameter balls to look like Europa and Ganymede, mottled brown and greyish colours. Paint the smallest ball to resemble Calisto, a dark mottled brown and grey.
Cut the wire into the following sizes: one 4-inch length, one 5-inch length, one 6-inch length, one 8-inch length and three 12-inch lengths. Bend the three 12-inch lengths of wire in the middle to form an L-shape with a gentle curve. Try to make each one even.
In the centre of the cardboard square, use a cup to draw a perfect circle. Divide the circle evenly into three sections, like a pie. On the circle, poke holes into the cardboard with the pencil at the "thirds" marks.
Feed the L-shaped wires through the bottom of the cardboard. Use duck tape to secure the bottom parts flat underneath the square. When you turn the square over, face up, you'll have three wires sticking straight up. Paint the top of the square black, to represent space. Allow it to dry.
Center and press your Jupiter sphere onto the three wires, sinking it in approximately three or four inches. Try to do this once, as you will weaken the styrofoam by moving the wire in and out of it. This will make your planet stand up.
Push one end of the 4-inch length of wire into your Io moon. Push one end of the 5-inch wire into your Europa moon. Push one end of the 6-inch wire into your Ganymede moon. And push the end of the 8-inch wire into your Calisto moon. Push the other ends of the wires into your model of Jupiter so that the planets are spaced out around it. Refer to a visual image of Jupiter and it's satellites to help you decide your placement.
Things you need
- 12-inch diameter styrofoam ball
- 2-inch diameter styrofoam ball
- 2, 1-inch diameter styrofoam ball
- ½-inch diameter styrofoam ball
- Craft paint
- Craft paint brushes
- 12-inch square heavy cardboard
- Thin wire, such as floral wire
- Duck tape