How to Build a VHF UHF TV Antenna
antenna image by domyre from Fotolia.com
A UHF VHF antenna is an antenna that connects outside your home or inside and is connected to your TV by a digital converter box. The UHF VHF antenna allows you to pick up and view free over-the-air TV channels.
UHF VHF antennas are best mounted outside to pick up signals but can also be used indoors if mounted on the ceiling. You can build your own UHF VHF antenna.
Remove 21 or 22 inches of the outer insulation of the coaxial cable and the shield of the wire from one side of the inner coaxial cable. Be careful not to cut into the coaxial cable or you will have to start over. The goal is to leave the 21 to 22 inches of cable exposed. Be sure to leave an inch for soldering the three radials to it.
- A UHF VHF antenna is an antenna that connects outside your home or inside and is connected to your TV by a digital converter box.
- UHF VHF antennas are best mounted outside to pick up signals but can also be used indoors if mounted on the ceiling.
Use a soldering gun to solder a radial cable to the shield of the coaxial cable near the end it is cut at. Take care to leave enough slack for the cable to have extra length for it to be soldered to the shield. Solder the other two coaxial cables to the single radial cable.
Spread the cables out in three equal directions. Each cable should be distanced 48.9 degrees Crom each other.
Hang the antenna from your support and attach the opposite end to your scanner.
Cassie Skelley has been writing articles about computers, electronics, video games and personal care for the Ikana Kai newsletter and Bon Losee Beauty College since 2005. Skelley majored in biology at Brigham Young University-Hawaii and in cosmetology at Bon Losee.