How to Control the Speed of a Single-Phase Motor

Written by james stevens
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Control the Speed of a Single-Phase Motor
Control the speed of your single-phase motor using a rheostat. (Hemera Technologies/PhotoObjects.net/Getty Images)

Single-phase motors generally operate at one speed and don't contain a device to select variable speeds. The speed the motor turns is determined by the voltage it gets from the power source; reduce the voltage and the speed of your single-phase motor decreases. Increase the voltage and the speed of your motor increases. Never increase the voltage above the input voltage labelled on the motor; that will burn out the motor windings. Install a variable rheostat and you can control your motor's speed.

Skill level:
Easy

Other People Are Reading

Things you need

  • Rheostat
  • Knife
  • Wire strippers
  • Screwdriver

Show MoreHide

Instructions

  1. 1

    Disconnect the single-phase motor from the power source. Use a knife and cut the wire that connects the motor to the power source. Make the cut about 12 to 18 inches away from the motor.

  2. 2

    Cut off about 2 inches of outer plastic from the two cut ends of wire using wire strippers. This reveals the inner wires. Remove ¼ inch of insulation on the two or three inner wires using wire strippers so you can see the copper wire.

  3. 3

    Loosen and then remove the screws on the rheostat cover using a screwdriver. Lift off the cover from the rheostat base. Locate the two plastic terminal blocks attached to the base of the rheostat. One is usually labelled "In" and the other "Out."

  4. 4

    Loosen the screws on the terminal blocks using a screwdriver; don't remove the screws. Using the wire that connects to the power source, insert the white or grey wire under the terminal screw labelled "-" or "Neu" on the "In" terminal block. Insert the black or red wire under the terminal screw labelled "+" or "Pos" on the same terminal block. If there is a third green wire, insert under the terminal screw labelled "Gnd" or "T." Tighten all the terminal screws.

  5. 5

    Repeat the procedure by connecting the two or three wires on the end of the wire that connects to the single-phase motor to the terminal block on the rheostat labelled "Out." The white or grey wire connects to "-" or "Neu," the black or red wire connects to "Pos" or "+" and, if there is a third green wire, it connects to "Gnd" or "T." Tighten the screws using a screwdriver.

  6. 6

    Replace the cover on the rheostat. Put the screws in the holes and tighten the screws using a screwdriver.

  7. 7

    Connect the wire to the power supply. Turn on your single-phase motor. Control the speed by turning the dial or moving the lever on the rheostat.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.