Viper remote start installation instructions

Written by joe mcelroy
  • Share
  • Tweet
  • Share
  • Email

Viper makes a large variety of automotive electronics aftermarket products, including security systems and remote starter kits. To successfully install a remote starter kit, it is best if your car is already equipped with a factory keyless remote entry system. The remote start will turn the engine and some accessories on, but you will not be able to drive the car until you physically put the key into the ignition and turn it to the on position. The system allows you to warm your engine up before getting into the car.

Skill level:

Other People Are Reading

Things you need

  • Socket set
  • Screwdriver set
  • Wire cutters
  • Soldering iron and solder
  • Digital voltmeter or multimeter
  • Electrical tape
  • Heat gun
  • Car owners manual
  • Safety gloves
  • Safety goggles

Show MoreHide


  1. 1

    Start your car and check to make sure all lights and accessories are in proper working order before beginning the installation. All lights and accessories must be in proper working order to complete a successful installation.

  2. 2

    Read the instruction manual that came with your kit thoroughly before beginning the installation. Viper makes several different types of remote starter sets, each with slightly different features. You should be familiar with all the procedures unique to your kit before you get started.

  3. 3

    Disarm the factory antitheft system on your car. Do this by pressing the unlock button on the keyless entry fob, then putting the key into the driver's side door and physically turning it to the unlocked position. Check your car owner's manual to see if your vehicle is equipped with a passive antitheft system. These systems prevent anyone from hot-wiring your car or tampering with the ignition switch. If your car is so equipped, you will need a transponder bypass before proceeding with the installation of the Viper remote start system. See References for a complete guide to transponder bypasses.

  4. 4

    Remove the panel beneath the steering wheel. Inside of it are the wiring connections needed to connect the remote starter. These include the power, ignition, accessory, starter, parking light and brake wires. Put on the safety gloves and goggles, then identify each wire using the voltmeter or multimeter, installation kit instructions and car owner's manual. There may be more than one wire in a particular bundle. Use a relay to connect multiple wires from the same bundle after you have disconnected the battery.

  5. 5

    Disconnect the battery, then make all connections with the kit. Solder the connections, then secure them with electrical tape after the solder has cooled. Recheck your instruction packet after each connection before proceeding to the next.

  6. 6

    Re-connect the battery and test the remote start and all accessories before putting the cover panels back in place. If any system does not work, recheck the connection and secure it properly. Once everything tests satisfactorily, you may replace the covers and drive the car.

Tips and warnings

  • Take pictures with a digital camera after you have removed the covers to help you remember how the wires and components should be properly connected. This will help you in reassembly and to troubleshoot any problems you might encounter during the testing process.
  • When you do complex electrical or electronic installations yourself, you are responsible for any faulty work. A faulty installation can cause damage to the car's electronic and computer systems. A professional installation will protect any remaining warranty you have on the car and against any installation errors.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.