How to Make a Boatswain Mate Lanyard

Written by eric cedric
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Make a Boatswain Mate Lanyard
Keep the whistle on the lanyard if you are the boatswain. (rowing image by Goran Bogicevic from Fotolia.com)

A boatswain's lanyard (or b'osun for short) holds a small whistle that is used to call directions and signal the crew. The lanyard becomes a sentimental article and should reflect the team colours or the boatswain's tastes. A lanyard may be in any colour scheme chosen or have beads and decorations if desired. Follow a basic formula to begin braiding a basic boatswain's lanyard and add your own decorative touches to make it custom.

Skill level:
Moderate

Other People Are Reading

Things you need

  • 5mm nylon cord, three different colours of your choosing
  • Measuring tape
  • Utility knife
  • Lighter
  • Metal cord sleeves
  • Crimpers
  • Dental floss
  • Metal key clip
  • Decorative beads or decorations (optional)

Show MoreHide

Instructions

  1. 1

    Cut three length of 5mm nylon cord at least 24 inches long. Hold the cut tips under the lighter to melt the nylon and prevent fraying. Hammer the tip of a framing nail to a post or board and tie the ends of the three cords to the nail.

  2. 2

    Hold the centre cord and bring the right hand cord up and over both the centre and left hand cord. Pick up the middle cord -- what was just the left hand cord -- and pull it over the right hand cord to make it the new right hand end. Continue this braiding process going down the cord lengths.

  3. 3

    Slide beads onto the braid as you move down the cords to add custom decoration. Slide the bead through all three cords to ensure the bead stays in place. Slide the metal cord sleeve up onto the braided lanyard when the ends are reached. Make a loop out of the braided lanyard and slide it through the metal sleeve so it forms an enclosed loop above the sleeve. Crimp down the sleeve to make the loop secure.

  4. 4

    Wrap the open end of the lanyard with at least 12 wraps of the dental floss and slip the metal key clip into the floss so it is threaded through the small loop hole. Cut the floss and tie it off at the lanyard end using a square knot.

  5. 5

    Clip the whistle to the key clip on the end of the lanyard and place the enclosed loop around the neck.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.