How to use alum in my pool water

Written by kristi roddey
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to use alum in my pool water
Alum helps clarify dirty pool water. (Jupiterimages/Photos.com/Getty Images)

Aluminium sulphate, also called alum, aids swimming pool filters to maintain clean and clear water. You can also spread it on the pool's surface. It attracts dirt particles and coagulates them so you can clean them out of the pool with ease. Alum comes in powder form and is readily available anywhere that sells swimming pool supplies. You can combine the powder with water to make a slurry to add to the water, but the quickest and easiest method is to add it straight to the sand filter or pool's surface.

Skill level:
Easy

Other People Are Reading

Things you need

  • pH test kit
  • pH increaser
  • pH decreaser
  • Pool vacuum

Show MoreHide

Instructions

    Added to Sand Filter

  1. 1

    Test the pool's pH level with a kit available at pool supply stores. Dip the included litmus paper into the pool water and read the results according to package instructions.

  2. 2

    Apply pH increaser or pH decreaser to the water to achieve a pH level in your pool of 7.0 to 7.2. These products are readily available at pool supply stores.

  3. 3

    Turn on the pool's circulation system.

  4. 4

    Add 1 pound of alum for every square foot of filter area through the skimmer. Check the manufacturer's label on the filter to find the square footage.

  5. 5

    Vacuum any sediment, or floc, that escapes the filter.

  6. 6

    Readjust the pH level of the pool to its normal level.

    Spread Over Surface

  1. 1

    Adjust the pool's pH level to 7.0 to 7.2 using a pH increaser or decreaser and a pool pH test kit available at pool supply stores.

  2. 2

    Turn on the pool's circulation system.

  3. 3

    Add between 1.81 and 3.63 Kilogram of alum per 10,000 gallons of water. Use 3.63 Kilogram per 10,000 gallons for extremely dirty water.

  4. 4

    Turn off the circulation system after four hours or when the pressure gauge on the filter reaches the limit set by the manufacturer.

  5. 5

    Wait six to 12 hours for the sediment to settle on the bottom of the pool.

  6. 6

    Vacuum the sediment from the pool, taking special care not to disturb the water more than necessary. Excessive motion in the water will cause the sediment to break apart, making it more difficult to vacuum.

  7. 7

    Replace the water you removed while vacuuming to achieve the desired water level in the pool.

  8. 8

    Adjust the pH level back to its normal level.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.