How to Mount a License Plate on a Trailer

Written by nicole schmoll
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Mount a License Plate on a Trailer
Mounting a number plate to a trailer requires a simple kit and a little elbow grease. (red horse trailer image by studio vision 1 from

States require trailers to have number plates with lights mounted to them to properly identify them. Lamps help protect drivers and trailers from collisions on the road, by flaring when the driver steps on the vehicle's brakes, to which the trailer is connected. Mounting a number plate onto a trailer is a simple process that anyone can perform with a number plate mounting bracket.

Skill level:

Other People Are Reading

Things you need

  • Trailer number plate
  • Number plate mounting bracket and trailer lamp kit
  • Heat shrink, waterproof wire connector
  • Terminal pliers
  • Hand lighter

Show MoreHide


  1. 1

    Purchase a number plate mounting bracket and lamp kit from your local auto parts dealer. Attach the number plate mounting bracket to your number plate using two bolts and nuts. Set the mounting bracket against the back of your trailer number plate and thread two bolts through the holes. Tighten with two nuts so that when looking at the front of the number plate, the mounting bracket steps down and forward.

  2. 2

    Remove the mounting bolts from your trailer plate lamp and set them aside. Thread the remaining screws through the two holes on the top of the number plate mounting bracket so that the light shines down upon the plate, in accordance with state law.

  3. 3

    Locate two holes on the rear wheel of your trailer and insert the two screws protruding from the back of the lamp (which is now connected to the number plate via the mounting bracket) into the wheel base surrounding the left or right trailer wheel.

  4. 4

    Hold the light flush against the wheel base with one hand and thread two lock washers followed by two retaining nuts onto the back of the lamp, on the underside of the wheel base. Tighten the retaining nuts with your fingers first and then use a size 10mm socket wrench to secure them to the wheel base, which may require about six to eight turns of the socket wrench.

  5. 5

    Grab the lamp's three wires which are hanging down from the device between your fingers and connect them to the grounding wires on your trailer using a heat shrink, waterproof connector and hand lighter.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.