How to replace front bumper cover toyota

Written by cameron easey
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to replace front bumper cover toyota
Bumper covers are attached plastic pieces. (dinosaurs image by Scott Williams from Fotolia.com)

Replacing the front bumper cover on your Toyota is a task that you can complete to upgrade the look of your vehicle. This will require removing the plastic clips and screws that are used to secure it to the inner bumper. You can also replace the bumper cover when it is cracked or has been damaged. Learning how to replace the front bumper cover will allow you to make changes and fix your vehicle in the future.

Skill level:
Moderate

Other People Are Reading

Things you need

  • Screwdriver
  • Pry bar

Show MoreHide

Instructions

    Remove Bumper Cover

  1. 1

    Locate the two screws that are securing the outer bumper cover to the frame, inside each bumper well at the front of the vehicle. Remove the screws from the bumper well on one side of the vehicle. Remove the screws from the other bumper well.

  2. 2

    Locate the plastic clips that are behind the surround on the grill, if applicable for your vehicle. There should be two clips on each side of the surround and one in the middle. Pop the plastic clips out with the flathead screwdriver.

  3. 3

    Look under the front bumper cover to find the screws that are used to secure the bottom of the cover to the inner bumper. Remove all of the screws that are under the front bumper cover with the screwdriver.

  4. 4

    Examine around the bottom of the front bumper cover and look for any additional screws that you may have missed. Remove them with the screwdriver.

  5. 5

    Pry on one side of the bumper cover with the pry bar to separate it from the inner bumper. Repeat this step on the other side of the vehicle and then pull the bumper cover off of the vehicle.

    Install New Bumper Cover

  1. 1

    Attach the new bumper cover to the inner bumper. Push on the grill surround to engage the plastic clips.

  2. 2

    Insert a screw into the screw hole in one of the bumper wells and tighten it with the screwdriver. Repeat this step on the other bumper well.

  3. 3

    Secure the bottom of the new bumper cover with screws. Insert a screw into each of the screw holes and then tighten them with the screwdriver.

Tips and warnings

  • If the screwdriver is not working to remove the screws you can use a power drill.
  • Do not force the plastic clips off from the grill surround because they can break.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.