How to Fix Gaps in a Refrigerator Door Gasket

Written by kenneth crawford
  • Share
  • Tweet
  • Share
  • Email

Gaps in the seal of your refrigerator door make your unit run less efficiently. There are a few things you can do instead of replacing the gasket. Knowing how to fix gaps in a refrigerator door gasket can save you money. For the gasket to seal properly, it must contact the refrigerator at the same time from the top and bottom. Most repairs to eliminate gaps are a matter of fixing a toe in or toe out issue with the refrigerator door.

Skill level:
Moderately Easy

Other People Are Reading

Things you need

  • Torpedo level
  • Wrench set
  • Socket wrench set
  • New refrigerator gasket

Show MoreHide



  1. 1

    Inspect the cabinet leveller and adjustable wheels. Place a torpedo level on top of the refrigerator and make sure it is level. If not, adjust the levellers or wheel underneath the unit.

  2. 2

    Move the leveller or wheel up or down by using a wrench to rotate the adjustment nut. Once the refrigerator is level, the door should seal all the way around.

  3. 3

    Open the refrigerator door, and loosen the inner panel mounting screws using a socket wrench or nut driver. Loosen from the top, bottom and handle side but not from the hinge side of the door. Do not remove the screws.

  4. 4

    Hold the toe-in side of the door stationary while pushing down on the toe-out corner of the door. Close the door, and check the seal.

  5. 5

    Tighten the screws back down when the inner door is aligned square with the cabinet.

    Gasket Replacement

  1. 1

    Purchase a door seal for your refrigerator at an appliance repair shop if the previous steps did not correct the problem. Be sure to have the refrigerator brand and model number with you when requesting the gasket.

  2. 2

    Fill the kitchen sink with warm water, and place the new gasket in the sink. This will make the new gasket easier to work with when installing.

  3. 3

    Remove everything from inside the refrigerator door.

  4. 4

    Loosen, but do not remove, the inner door retaining screws located behind the gasket.

  5. 5

    Pull the old gasket away from underneath the metal retainer and off of the door. Install the new gasket underneath the metal retainer starting at the bottom of the door.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.