How to Wire an Advance T5 Ballast

Written by steve bradley
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Wire an Advance T5 Ballast
A good pair of wire cutters is one of the only tools you need to wire an Advance T5 ballast. (Pliers and wire cutters image by Albert Lozano from Fotolia.com)

Every do-it-yourselfer has an area that he just does not feel comfortable in. For some people, it is plumbing; for others, it is electrical work. However, even if working with wires intimidates you, one job anyone can do it the wiring of an Advance T5 ballast in a fluorescent light fixture. The ballast is the black, rectangular-shaped box that regulates how much electricity can flow into the tubes. Over time, this ballast will burn out. To replace it, you have to disconnect the wires and wire in a new ballast.

Skill level:
Easy

Other People Are Reading

Things you need

  • Screwdriver set
  • Wire cutters/strippers
  • Electrical tape

Show MoreHide

Instructions

  1. 1

    Cut the power to the fixture. Do this by unplugging the light from its outlet, or, if this is not possible, going to the basement or utility closet and cutting the power at the fuse box.

  2. 2

    Access the old ballast. Remove any accessories that are on the fixture, including the light tubes. Then take off the casing. Accomplishing this step requires nothing more than a screwdriver. Once the fixture is open, notice the rectangular black box; this is the ballast.

  3. 3

    Disconnect and remove the old ballast. First, clip the four coloured wires extending from the ballast to the fixture. Cut them as close to the ballast as possible. Then unscrew the mounting screws holding the ballast onto the fixture. Remove the old ballast.

  4. 4

    Strip the wires. Use the wire stripping function of your cutters and take off about 1 inch of insulation from each of the wires coming from the fixture. This will allow you to connect them to the new ballast.

  5. 5

    Attach the new Advantage T5 ballast with the same mounting screws. Twist together each coloured wire from the new ballast with the same-coloured wire from the fixture; black to black, red to red, and so on. Cover each twisted connection with electrical tape to prevent a short, or worse, a house fire.

  6. 6

    Reassemble the light fixture and turn back on the power.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.