How Do I Administer Sustanon 250?

Written by lynndee marooney
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How Do I Administer Sustanon 250?
Body builders use Sustanon 250, a steroid, to increase muscle mass. (injection image by sasha from Fotolia.com)

Sustanon 250, a testosterone-based steroid, is designed to be administered via injection into the muscle. Sustanon 250 contains a blend of testosterone esters that make it more difficult for the body to metabolise the hormones. This helps prevent immediate metabolism, thus extending the life of the steroid. Common sites used for injection are the upper buttock, upper arm, and thigh. Proper technique and clean supplies should always be utilised with the administration of Sustanon 250.

Skill level:
Moderate

Other People Are Reading

Things you need

  • Syringe
  • Vial of Sustanon 250
  • Alcohol pads
  • Needles

Show MoreHide

Instructions

  1. 1

    Attach a needle to the syringe. Pull back the plunger and draw up the same amount of air as the amount of steroid you will inject. Example: If your dosage is 3cc, pull back the plunger on the syringe to fill the syringe with 3cc of air.

  2. 2

    Clean the top of the vial with an alcohol swab. Turn the vial upside down and push the needle through the top of the vial. Inject the air into the vial and then slowly pull back the plunger and draw up the correct dosage. Place the cap back on the needle.

  3. 3

    Change the needle if you wish. Pushing the needle into the vial can slightly dull the needle, causing more discomfort if used for the injection. A new needle will ensure a nice, sharp point.

  4. 4

    Select the site of injection. The upper buttock is the most common site for an intramuscular injection. To find the correct location, divide the buttock into two portions--upper and lower. Use the upper outside area for the injection.

  5. 5

    Clean the injection site by wiping with a fresh alcohol wipe. Do not touch the cleaned area with your fingers. Hold the area around the injection site with your finger and thumb, and pull the skin taut if possible.

  6. 6

    Hold the syringe at a 90-degree angle, and with one swift motion inject the needle. Pull back on the syringe slightly and check for blood. If you see any blood being pulled into the syringe, take the syringe out and inject in another location. Inject the Sustanon 250 slowly if you do not see any blood.

    Steroids in an oil base can take longer to inject. Slow and steady pressure might be required. Use a cotton pad or ball to apply pressure to the site for a few moments.

Tips and warnings

  • Use the muscle of the upper arm or thigh as additional injection sites.
  • A 1.5-inch, 22- or 23-gauge needle is best for injecting anabolic steroids.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.