How to Troubleshoot an Evinrude Tilt & Trim

Written by will charpentier
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Troubleshoot an Evinrude Tilt & Trim
(Jupiterimages/Photos.com/Getty Images)

When troubleshooting the FasTrack Tilt and Trim system on your boat's Johnson outboard motor, your first efforts may be dedicated to replacing good parts in an effort to eliminate the cause of a system that refuses to move. This means you'll either have a ready supply of spare parts that you know are serviceable, or you'll need to have an understanding parts counter person at the dealership willing to accept all the returns. If the system moves, but groans or sounds strange, the fixes aren't as time-consuming or costly.

Skill level:
Challenging

Other People Are Reading

Things you need

  • Manual release valve
  • Trim motor coupling
  • FasTrak pump manifold
  • FasTrak O-ring kit
  • Replacement fluid valve kit
  • Replacement impact valve kit
  • Hydraulic fluid

Show MoreHide

Instructions

  1. 1

    Close the manual release valve if the system won't move in either direction. If the unit still won't move, replace the manual release valve; if the symptoms disappear, the relief valve was the cause. If not, remove and replace the coupling on the trim motor. If the problem persists, install a pump manifold. If the problem persists, install an O-ring kit in the cylinders. Look for chipped fluid valves or impact valves and replace them if needed.

  2. 2

    Open the hydraulic reservoir and check the fluid level if the engine tilts part of the way up, but doesn't move smoothly. Refill the reservoir with hydraulic fluid all the way to the bottom of the reservoir's filler neck. Bleed any air from the system by raising and lowering engine -- in ten second increments -- all the way up and all the way down with the trim/tilt motor for at least five complete cycles, checking the hydraulic fluid level in the reservoir after each cycle. Top off the hydraulic fluid after each cycle, if necessary.

  3. 3

    Open the manual release valve and tilt the motor up and down by hand if the motor seems to be binding when you raise or lower it. When you find the spot where the system is binding against itself or another part of the boat, do whatever is needed to relieve the bind.

Tips and warnings

  • The FasTrak tilt and trim system was in general use on Johnson motors built after 1990.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.