How to Make a Concrete Apron

Written by sal marco
  • Share
  • Tweet
  • Share
  • Email

A concrete apron is the portion of a driveway that extends from the street and 8 to 10 feet into the driveway space or in front of a garage to transition from the driveway to the garage surface. Installing a concrete apron around a building directs the flow of water away from the foundation. Pouring an apron between streets or garage doors provides extra support to an asphalt driveway and minimises damage to the asphalt.

Skill level:
Moderately Challenging

Other People Are Reading

Things you need

  • Wooden stakes
  • Shovel
  • Tamper
  • 2-by-8-inch boards
  • Crushed stone
  • Board
  • 1-by-2-inch boards
  • Wire-reinforcing mesh
  • Shears
  • Bull-float
  • Pry bar

Show MoreHide


  1. 1

    Check all local building codes to determine the correct apron size.

  2. 2

    Drive wooden stakes into the ground marking off the apron.

  3. 3

    Dig the ground down 6 inches inside the confines of the stakes.

  4. 4

    Tamp the base of the excavation with a hand tamper or rent a gas-powered tamper to compact the dirt tightly.

  5. 5

    Lay 2-by-8-inch boards, standing up on the 2 inch side of board, around the perimeter of the dig, to form a mould which will hold wet concrete in place.

  6. 6

    Add 2 inches of crushed stone to the base of dig.

  7. 7

    Sweep a long board over the stone to level out the surface.

  8. 8

    Lay a 1-by-2-inch board perpendicular to the 2-by-8-inch form lying across the stone to create an expansion joint if the apron is longer or wider than 8 feet. An expansion joint allows subtle concrete shifting due to ground movement and freeze-thaw patterns, which keeps the concrete from cracking.

  9. 9

    Lay wire-reinforcing mesh over the crushed stone. Trim the wire-reinforcing mesh with shears to fit between the forms and the expansion joints.

  10. 10

    Call a concrete company and schedule a pour of a minimum of 4,000 PSI concrete. PSI, pounds per inch, dictates the amount of weight concrete is able to withstand.

  11. 11

    Pour a 4 inch thick layer of concrete over the wire-reinforcing mesh.

  12. 12

    Move concrete up to the edges of the forms and expansion joints with a shovel.

  13. 13

    Sweep a long board over the top of the wet concrete to level high spots and fill in low spots.

  14. 14

    Use a bull-float, which is a trowel-like tool at the end of a long pole, to smooth the concrete surface.

  15. 15

    Allow the concrete to set and break away forms with a pry bar, leaving the expansion joints in place.

Tips and warnings

  • Slope aprons away from foundations and garages at a rate of 1 to 2 inches per 3 feet.
  • Add colour to the concrete to maintain uniformity between asphalt and aprons.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.