Over time, the pipes of your home can become damaged and leak. The damage can vary from a hole bored into the pipe by corrosion, to a crack in a PVC pipe. You can repair the majority of pipe damage without cutting and replacing sections of the pipe or welding patch plates onto galvanised pipe. If you follow the directions of the pipe repair kit, the repair will be permanent, and it can be used on nearly all types of piping.
Things you need
Fine-toothed flat file
Fibreglass pipe repair kit
Glass of water
Turn off the water, if you are repairing a water supply line, and turn on the faucets of the home to drain the water from the line.
Run a fine-toothed flat file over the area of the leak to clean the surface of the pipe and create a bonding surface for the pipe repair.
Remove the epoxy putty from the fibreglass repair kit and knead the epoxy for the time specified in the pipe repair kit instructions.
Apply the mixed epoxy putty to the leaking area of the pipe. Work the epoxy onto the surface of the pipe to ensure that you remove all the air from the epoxy.
Put on a pair of rubber gloves, and dip the roll of resin-impregnated fibreglass into the water two or three times.
Wrap the wet fibreglass roll around the damaged area of the pipe.
Massage the fibreglass, after you have wrapped the entire roll of fibreglass around the pipe, to remove air from the fibreglass tape.
Allow the fibreglass repair to cure for the time recommended on the pipe repair installation instructions before you turn on the water. If you turn the water on before the repair has cured, the water will break the bond between the fibreglass tape and the surface of the pipe.
Turn on the water, wait 30 minutes and then inspect the repair for leaks. If you notice a leak, you will need to apply an additional roll of fibreglass tape to seal the damaged pipe.
Things you need
- Fine-toothed flat file
- Fibreglass pipe repair kit
- Rubber gloves
- Glass of water