How to Build a Homemade FM Antenna for a Radio

Written by kenneth coppens
  • Share
  • Tweet
  • Share
  • Email

Antennas intercept waves from radio transmitters that enable you to listen to your favourite radio stations at home, at work or in the car. A standard antenna used to pick up FM radio is perhaps the simplest antenna of all. An FM radio antenna is nothing more than a thin piece of wire inside a metal casing. Whether you want to improve the efficiency of an existing antenna or make an entirely new one, you can do it quickly and inexpensively.

Skill level:
Moderately Easy

Other People Are Reading

Things you need

  • Speaker wire
  • Utility knife
  • Wire stripper
  • Wire staple or tape

Show MoreHide


  1. 1

    Cut speaker wire to a length of 6 feet. You might not need the entire length, but it's better to have too much wire than not enough.

  2. 2

    Strip the coating about an inch off one end of the wire with a pair of wire strippers. This will leave you with bare wire. Wrap the wire around the existing antenna or insert the wire into the hole for the antenna.

  3. 3

    Split the speaker wire on the other opposite end with a utility knife to get the two colours of wire separated from one another. Be cautious when doing this to avoid cutting the actual wires.

  4. 4

    Hold the wire flat against a wall in any spot you wish. Secure the wire in place with a wire staple or tape. You should have a foot of wire sticking up from the top of the staple or tape.

  5. 5

    Pull the two halves of the wire apart until they reach the point of the staple or tape. Spread the two halves apart and secure them to the wall.

  6. 6

    Cut off any excess wire, if necessary.

Don't Miss


  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.