How to Sand Glass for a Frosted Effect
Frosted glass is so named because it resembles the look of a delicate coating of ice crystals on a winter window. This lovely, semi-opaque effect gives glassware an expensive-looking charm. Creating it, however, is as simple as treating glass with a sanding tool and ordinary sandpaper.
Give a new look to everyday glass items, and transform plain glass into a keepsake.
Draft an outline of the frosted shape you want using permanent marker. Erase mistakes using a cotton swab dipped in nail polish remover, and redraft as you go.
- Frosted glass is so named because it resembles the look of a delicate coating of ice crystals on a winter window.
- Draft an outline of the frosted shape you want using permanent marker.
Cover the area you do not want frosted with a coat of masking tape or blue painter's tape. For particularly tight corners and curved edges, tear or cut the tape into the right shape and use very small pieces.
Fit the rotary power tool with a detail sanding bit according to the tool manufacturer's instructions. Use a new, previously unused bit for best results.
- Fit the rotary power tool with a detail sanding bit according to the tool manufacturer's instructions.
Set the tool to a medium speed level on its dial (the exact number will vary from model to model, so check to see how high the numbers go).
Sand the glass inside the area you outlined using short strokes of the sanding bit. Do not leave any spot unsanded, and remove all smooth, clear areas within the section you outlined. Avoid bumping the masked areas; the tape will only provide some protection.
Tear a small circle of sandpaper. Make it small enough that you can move and manipulate it inside the outline of the frosted area.
Smooth out the frosted area with the sandpaper circle using your fingertips. Strive to make its surface uniform. Replace it with another piece of sandpaper if it seems to be losing its effectiveness. If your shape has fine lines and narrow areas, fold the paper in half and sand with the folded edge.
Remove the tape.
Wipe away any remaining permanent marker lines.
- "The Big-Ass Book of Crafts;" Mark Montano and Auxy Espinoza; 2008
- If you do not want to draft your frosted glass shape by hand, trace an image printed on paper by taping it against the reverse side of the glass.
Lauren Vork has been a writer for 20 years, writing both fiction and nonfiction. Her work has appeared in "The Lovelorn" online magazine and thecvstore.net. Vork holds a bachelor's degree in music performance from St. Olaf College.