How to Attach Corrugated Fiberglass Roof Panels

Written by samantha belyeu
  • Share
  • Tweet
  • Share
  • Email

Corrugated fibreglass panels are made of synthetically produced glass fibres, designed to provide a waterproof seal along with a tough, durable structure with a lifetime expectancy of 20 years. Fibreglass sheets are resistant to corrosion, chemicals, rust and mildew, and are also shatterproof (unlike glass greenhouses), and require minimal maintenance. Panels are typically 26 inches wide and up to 20 feet long, and are available in clear or white. Their light weight and ability to be nailed, drilled, sawn and punched without damaging the sheet as a whole makes them relatively easy to install.

Skill level:
Moderate

Other People Are Reading

Things you need

  • Corrugated fibreglass panels
  • Framing/rafters
  • Power screwdriver
  • Filler strips
  • Drill
  • Fibreglass panel nails
  • Hammer
  • Plastic washers
  • Caulk
  • Power saw with a blade for cutting fibreglass
  • Ridge caps

Show MoreHide

Instructions

  1. 1

    Build the greenhouse frame if it does not already exist. Remove any old panelling from existing frames along with the corresponding nails or screws, leaving just the smooth-faced frame.

  2. 2

    Install filler strips (pieces of wood shaped to fit the corrugation of the panels) under the roofing at the eaves to ensure a complete weather seal. Filler strips generally come with fasteners or screws, but if not, pre-drill screw holes and screw them onto the eaves.

  3. 3

    Lay a corrugated fibreglass panel against the rafter, and have a helper hold it in place. The grooves should direct water down from the top of the greenhouse roof. Pre-drill holes for the fibreglass panel nails and hammer the first full-width panel to the rafters. Use four nails across the panel where it rests on each rafter, making sure that the roofing is snug to the framing.

  4. 4

    Place the next panel so that it overlaps into the groove of its neighbour panel. Apply a beaded line of adhesive caulk on both the overlapping surfaces and press them securely together to form a seam. Nail the second panel using the same method as the first. Repeat the procedure to complete the installation of the remaining full-width panels. If you have more than 20 feet to cover from eaves to ridge, lay the upper panels so that they overlap the lower panels by 12 inches. Cut the panels as necessary, using a saw blade for fibreglass to avoid cracks and catching.

  5. 5

    Install ridge caps at the ridge and any hips -- or any areas where the panels join at different angles -- after all panels are installed. The ridge cap should overlap the panels by at least 1 inch and sections of the ridge should overlap each other by 6 inches. Nail the ridge caps into the top of the frame using the manufacturer's guideline pattern, but do not nail overlapping sections of ridge caps.

Tips and warnings

  • Fibreglass panels are typically sold in kits together with manufacturer-specific nails, filler strips and caulk. During installation, refer to the manufacturer's specific instructions.
  • Use clear silicone caulk if the panels are translucent.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.