How to create a pewter faux finish
pewter jewerly box image by nutech21 from Fotolia.com
Pewter is a rugged, rustic metal with a dull silver finish flecked with black. It can be found in everything from beer mugs to candlesticks. One of the great things about pewter finishes is the matt sheen, which requires no polishing.
When preparing to apply faux finishes, choose items that you are reasonably certain you do not want in their current condition, because the process is difficult to reverse. Metal, wood and smooth plastics make ideal surfaces for this finish, which will be applied in two parts.
Sand or rough up the surface lightly with 220-grit sandpaper or ultra-fine steel wool, so the paint will adhere properly.
Set the item to be finished on a plastic tarp, or mask off around it with plastic and masking tape if it is permanently attached, such as a light fixture might be. Remove screws or similar pieces, as well as glass and other non-paintable surfaces, or cover them with masking tape.
- Pewter is a rugged, rustic metal with a dull silver finish flecked with black.
- Set the item to be finished on a plastic tarp, or mask off around it with plastic and masking tape if it is permanently attached, such as a light fixture might be.
Apply a coat of spray primer to the entire area to be faux-finished. Hold the can 8 to 10 inches from the surface and move it in stroking motions, keeping the can moving, releasing the trigger at the end of each stroke. Allow the primer to dry for 30 minutes.
Spray on a coat of flat black enamel using the same spray technique. Be sure to cover all of the primer so that none of it shows through the black. Allow the black coat to dry until it is completely dry to the touch.
Apply a coat of silver spray enamel. The cheaper paint gives a more convincing matt finish. Avoid paints that are advertised as chrome repair or have very high-gloss finishes; what you need is the right look. Apply the silver sparingly so that some of the black shows through in a few places to give dark grey shadows. Work to prevent runs and drips by spraying in short bursts.
- Apply a coat of spray primer to the entire area to be faux-finished.
- Allow the black coat to dry until it is completely dry to the touch.
Dust the silver with a few very light strokes of black to give the feeling of the porous surface. Hold the can farther back and work in very short, stationary bursts. This will speckle the silver and add depth to the finish. Don't worry if you go too far; more silver can be added. Once you have the look you are happy with, stop.
Apply a coat of matt clear enamel spray finish over the silver to seal the finish.
- "Decorative Paint and Faux Finishes": Jeanne Huber; Sunset Books, 2006
- "Air Brushing and Spray Painting Manual": Ian Peacock; Argus, 1985
Mark Morris started writing professionally in 1995. He has published a novel and stage plays with SEEDS studio. Morris specializes in many topics and has 15 years of professional carpentry experience. He is a voice, acting and film teacher. He also teaches stage craft and lectures on playwriting for Oklahoma Christian University.