We Value Your Privacy

We and our partners use technology such as cookies on our site to personalise content and ads, provide social media features, and analyse our traffic. Click below to consent to the use of this technology across the web. You can change your mind and change your consent choices at anytime by returning to this site.

Update Consent
Loading ...

How to Change Brake Pads on a Fiat Scudo

Updated April 17, 2017

Replacing the brake pads on your Fiat Scudo will save you hundreds of dollars. Not only will you save money in the process, but you will also get the satisfaction of repairing your own vehicle. When replacing the brake pads on the car, it is recommended to replace the rotors as well so the new brake pads have an even surface to push against when braking. Replacing the brake pads as well as the rotors will ensure that your brakes last as long as possible.

Loading ...
  1. Lift the Fiat Scudo with the jack and place it on jack stands.

  2. Remove the wheels with a lug nut wrench and set them aside. The lug nut wrench can be found in the boot of your Scudo. If you cannot find it, you can also use a ratchet and 19mm socket.

  3. Remove the caliper with a ratchet and use a bungee cord to hang the caliper. Do not let the caliper hang from the brake hose as it might break and cause fluid to leak.

  4. Remove the brake caliper bracket from the steering knuckle with a ratchet and set it aside.

  5. Remove the brake rotor from the hub. The rotor might require force to remove; if it does, use a hammer to hit the rotor in the centre where the lug studs are located. Take care not to hit the studs.

  6. Remove the new rotor from its packaging and use brake cleaner to remove the grease from the rotor. Grease is put on the rotor in the factory to inhibit rust during storage.

  7. Install the new rotor onto the hub.

  8. Install the caliper bracket with new brake pads installed onto the rotor and fasten it to the steering knuckle. Use a ratchet to tighten the bolts.

  9. Open the master cylinder reservoir so you don't break a seal while compressing the brake caliper.

  10. Compress the brake caliper with a C-clamp so the caliper can fit over the new brake pads. Install the caliper by securing it to the brake caliper bracket with a ratchet.

  11. Tip

    A brake caliper compressor might work better for you than a C-clamp.


    Wear safety glasses while working on your brakes.

Loading ...

Things You'll Need

  • Safety glasses
  • Jack
  • Jack stands
  • Lug nut wrench
  • Ratchet
  • Sockets
  • Hammer
  • New rotors
  • Brake cleaner
  • New brake pads
  • C-clamp

About the Author

Shayrgo Barazi

Shayrgo Barazi is a college graduate with a degree in automotive engineering technology (B.S.c.) from Ferris State University. He is a successful writer and has taken a college level technical writing course. He currently works for Time Wave Media writing automotive DIY articles. He has an intuition for technology and has the capacity to write, too.

Loading ...
Loading ...