Water that has found its way underneath ceramic tiles after a leak can cause mould growth. If left alone to grow, the mould can become very dangerous, as mould spores can cause respiratory problems. Not only is it harmful to breath in, mould is also unattractive. Water left to stand underneath ceramic tiles will eventually compromise the structure of the tile itself, causing it to crack or break.

Tap a rubber mallet on the head of a small chisel to remove the grout in the tile joints.

  • Water that has found its way underneath ceramic tiles after a leak can cause mould growth.
  • Tap a rubber mallet on the head of a small chisel to remove the grout in the tile joints.

Place a wide putty knife under the ceramic tile, parallel to the floor. Use the rubber mallet to tap the head of the putty knife to pop the ceramic tile from its place. Repeat this procedure for all ceramic tiles with underlying water. Set all the ceramic tiles you removed to the side.

Lay several thick towels down on top of the water area to soak up the moisture.

Chip away the old ceramic tile thin-set with the putty knife and mallet. You need a slightly smooth surface to replace the area with ceramic tile so they are even with the surrounding tile.

Locate the area where the water leaked out. Use caulking and plumber's putty to stop the leak from causing future damage.

  • Lay several thick towels down on top of the water area to soak up the moisture.
  • Locate the area where the water leaked out.

Put on a filter mask to protect them from mould spores. If the water was underneath the tiles for a long period, you will need to remove any mould before you replace the ceramic tiles.

Don a pair of rubber gloves to protect your skin from bleach. Pour 118 ml (1/2 cup) of bleach into a large container. Add 1.14 litres (1 quart) of water to the container, and place three to four drops of washiong up liquid in the solution. Stir with a wooden spoon so the mixture becomes soapy. Dip a scrub brush into the solution and allow the excess water to drip away. With small, circular motions, scrub away all mould growing in the area. Vacuum the area thoroughly with a wet shop vacuum. Ensure no mould particles are left behind to grow.

  • Don a pair of rubber gloves to protect your skin from bleach.
  • With small, circular motions, scrub away all mould growing in the area.

Mix thin-set tile mortar in a large container according to package directions. Apply a thin layer of thin-set onto the repaired area with the flat side of a metal trowel. Run the metal trowel over the layer of thin-set using the notched side. Place the old, undamaged or new replacement ceramic tiles on the thin-set mortar and wiggle to set in firmly. Insert a tile spacer around each piece of ceramic tile to create even joint spaces. Allow the thin-set to dry overnight.

Remove tile spacers and place premixed grout into a grout bag. Squeeze the grout in the joints of each ceramic tile. Smooth the grout lines with your finger. Allow the grout to set for 30 minutes. Wipe off excess grout on the ceramic tiles with a dampened cloth. Allow the grout to dry overnight.

  • Mix thin-set tile mortar in a large container according to package directions.
  • Smooth the grout lines with your finger.