How to Reseal a Bathtub

Written by samantha volz
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Reseal a Bathtub
Caulking around sinks and tubs prohibits damage caused by moisture. (Polka Dot Images/Polka Dot/Getty Images)

The sealing caulk spread around the bathtub of your home may seem like more of a nuisance than anything. It attracts mould, mildew and dirt, which are all too visible on the white surface. However, this seal actually is preserving the integrity of your bathroom. Without it, that moisture and mould would be infesting the walls of your bathroom, creating a dangerous environment in your home. If the seal breaks, you must reseal it as soon as possible to avoid moisture and mould build-up in the bathroom.

Skill level:
Moderately Easy

Other People Are Reading

Things you need

  • Razor blade or utility knife
  • Scraper
  • Rag
  • Solvent cleaner
  • Mold killer
  • Painter's tape
  • Caulk
  • Paper towel

Show MoreHide


  1. 1

    Run a sharp razor blade or utility knife along the top and bottom lines where the old sealant meets the bathtub and the wall. This will loosen the bond between the old seal and the bathroom installation. You must remove the old seal before you can replace it.

  2. 2

    Dig out all of the old sealing caulk using a scraper or utility knife. Be very careful not to scratch your walls or bathtub, as these scratches are not easily removed. Dig until all old sealant is removed. Any leftover sealant will create a weak point in the new seal.

  3. 3

    Dampen a rag in rubbing alcohol, white spirit or a similar solvent cleaner. Wipe out the entire area that you will reseal, as well as the bathtub surface below. This cleaner will remove any remaining small pieces of old sealant.

  4. 4

    Clean the area with bleach or a commercial mould killer if you see any mould or mildew in the sealant area. Mold left in there before you apply the new caulk will continue to grow and damage your walls, as well as undermining the new seal. Allow the area to dry completely before continuing.

  5. 5

    Run a line of painter's tape along the top of the tub, as well as the bottom of the wall piece, creating a little valley for the caulk. This will help you get a cleaner finish for the caulk without spilling it everywhere.

  6. 6

    Cut the tip of the caulk dispenser at a 45-degree angle to create a small, angled hole. This will ensure that only a little comes out at a time, reducing your chance of making a mess. You can cut the hole bigger as you become comfortable with it if you want to go faster.

  7. 7

    Run a steady, thin bead of caulk between the two pieces of tape to fill in the gap. Do one side of the tub first. You must complete the following steps while the caulk is still wet.

  8. 8

    Wrap a small piece of damp paper towel around your index finger. The damp towel stops the caulk from sticking to your finger instead of the wall and tub. Gently press the wet caulk into the seam, firming it in place. Add more caulk if necessary to fill the gap completely and press again. Continue until the gap is sealed completely.

  9. 9

    Remove the painter's tape while the caulk is still wet. The caulk will expand as it dries to fill in the small gaps left by the paint. Repeat the procedure for each side of the tub, until all gaps are sealed with caulk.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.