How do I adjust valves on an xr400?

Written by tracy underwood
  • Share
  • Tweet
  • Share
  • Email

The Honda XR400 is one of the most ubiquitous dirt bikes ever sold. They have proven to be reliable and trouble-free. But as with any other mechanical device, there are certain maintenance tasks the owner or a bike shop must perform periodically. Valve adjustments are one of these tasks. If you own one of these bikes, it is to your benefit to learn to adjust the valves yourself. You will save time and money, and it is easier than it looks.

Skill level:

Other People Are Reading

Things you need

  • XR400 shop manual
  • Metric hex wrench set
  • Metric combination wrench set
  • Metric socket set
  • Breaker bar
  • Screwdriver set
  • Shop towels

Show MoreHide


  1. 1

    Turn off the fuel petcock. Follow the directions in the shop manual to remove the side covers, seat and gas tank.

  2. 2

    Remove the crankshaft access cap and the timing access cap. The crankshaft cap is in the centre of the engine cover on the left side of the bike. The timing cap is just above the crankshaft cap. Remove both -- turning counterclockwise with a hex wrench.

  3. 3

    Locate the valve adjusting caps. They are on top of the cylinder head; two each on the front and back. Use a shop towel to clean any debris off the caps. Turn each cap counterclockwise with a wrench to remove.

  4. 4

    Loosen the locknut in each valve adjustment port, under the caps you removed in step three. This takes a 7mm wrench.

  5. 5

    Use a 12mm socket and a breaker bar to turn the crankshaft counterclockwise to align the "T" mark in the timing access hole.

  6. 6

    Use a flat blade screwdriver to back each valve adjuster out slightly.

  7. 7

    Adjust the intake valves. These are the two valves on the rear of the head. Insert the .004 inch or 0.10mm blade of the feeler gauge between the adjuster in the rocker arm and the sub-rocker just under it. Turn the adjuster screw, until it lightly contacts the feeler blade. You should be able to slide the blade with only slight resistance. Tighten the locknuts.

  8. 8

    Adjust the two exhaust valves on the front of the head. Use the same technique as with the intake valves, except use the .005 inch or 0.12mm blade. Tighten the locknuts.

  9. 9

    Replace the valve adjustment caps, crankshaft and timing caps, and the fuel tank, seat, and side covers.

Tips and warnings

  • Be careful not to spill gasoline when you remove the fuel tank.
  • Keep all flames and heat sources away.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.