How to Hang a Swing Between Two Trees

Written by lisa wampler
  • Share
  • Tweet
  • Share
  • Email

Connecting a swing to two different trees will work if the branches you want to connect to are within a few feet of each other and are heavy enough to support the weight. Using oak, ash or maple trees is best since their wood is relatively hard. Pine, walnut and poplar work as long as their branches are 12 inches in diameter and are healthy.

Skill level:

Other People Are Reading

Things you need

  • 2-by-8-inch oak
  • Mitre saw
  • Tape measure
  • Drill
  • Hole saw
  • Eyebolts
  • Washers
  • Nuts
  • Wrench set
  • Sanding block
  • Exterior latex paint or stain
  • Paintbrush
  • Nylon rope
  • Rope thimbles
  • Hacksaw

Show MoreHide


  1. 1

    Cut a piece of 2-by-8-inch oak approximately 16 inches long. The oak board will become the seat of your swing. If you want to make a double swing so two people can swing at the same time, cut the wood to a length of 32 inches. This works well if the branches are a bit farther apart. Use a mitre saw to cut the wood and then sand the edges with a sanding block to smooth the wood.

  2. 2

    Drill a hole approximately 2 inches from each end through the 8-inch face of the wood. Make the holes large enough to fit your nylon rope. Use a nylon rope at least 1 ½-inches in diameter. To cut the hole, you will need a hole saw and a hand drill.

  3. 3

    Paint the wood with a stain and sealer or with an exterior latex paint. Use a paintbrush or a sprayer for this. Allow adequate drying time per the instructions on the paint container. You can be as creative as you like with this step.

  4. 4

    Measure from the centre of one hole to the centre of the next hole and transfer the measurement to the two branches on the trees. Drill down through the tree branches with a drill bit and a hand drill.

  5. 5

    Place an eyebolt through each branch. Place a large washer onto the eyebolts and then secure them to the trees with a nut and a wrench.

  6. 6

    Tie a piece of nylon rope to a rope thimble and then secure the thimble to the eyebolt. Do the same with a second piece of rope and secure that thimble to the second eyebolt.

  7. 7

    Thread one rope through one hole in the swing. Tie a knot to hold the swing onto the rope. Thread the second rope though the second hole in the swing. Tie a knot in the rope to keep the swing in place. Make sure the swing is level.

  8. 8

    Cut off the excess rope with a hacksaw.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.