How to Install Steel Cladding

Written by richard may
  • Share
  • Tweet
  • Share
  • Email

Steel cladding is strong, durable and able to cope with large temperature changes. It can be installed in areas where the climate is harsh to protect buildings against snow, sleet and hail. Steel cladding can last around 20 years with very little maintenance other than occasional cleaning. Steel cladding is available in a variety of styles and paint finishes and is suitable for homes, shops and garages.

Skill level:
Moderately Challenging

Other People Are Reading

Things you need

  • Tape measure
  • Hammer
  • 1 1/2-inch aluminium nails
  • Spirit level
  • Corner caps
  • J channels
  • Circular Saw
  • Duct tape

Show MoreHide


  1. 1

    Clean the exterior walls of the building where the cladding is to be fitted. The walls must be free of dirt and any nails must be hammered in to avoid damaging the foam backing.

  2. 2

    Nail the foam backing to the wall and fix duct tape over each join. Start at the bottom corner of the wall and work along the wall before starting the next row. Leave a 2-inch gap at the bottom, top and corners of the walls and around door and window frames. Complete the whole area before starting to fit the steel cladding.

  3. 3

    Secure the starter channel along the bottom of the wall using 1 1/2-inch aluminium nails. Fit the corner caps over the corners of the walls and fit J channel around each window and door frame. Cut the channels and corner caps to size using the circular saw.

  4. 4

    Fix the first steel cladding sheet to the lower corner of the wall, sliding it into the starter channel. Hammer in place using 1 1/2-inch aluminium nails through the specially made fixing holes, but do not hammer in all the way because the steel expands and shrinks as the temperature changes.

  5. 5

    Fit the next sheet, overlapping the first by 2 inches to form a water-resistant barrier. Move along the wall, fitting each sheet until you finish the row. Check that the sheets are level as you fit them, using the spirit level.

  6. 6

    Cut 1 foot off the width of first sheet of the second row with the circular saw. Slot the cut end into the corner cap and nail in place using 1 1/2-inch aluminium nails. Fit the next sheet, overlapping the first by 2 inches. The vertical seam will be staggered from the previous row. Start the next row with a complete sheet and the one after that with a cut sheet.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.