The carrier bearing on a Chevrolet Equinox acts as a support for the driveline. This bearing mounts between the two halves of the driveshaft and bolts to the chassis. If the bearing wears down, the driveshaft will rattle around the underside of the vehicle. This will cause a vibration problem until eventually the driveshaft will fail. To fix the issue, replace the carrier bearing on the Equinox. The job should take about two hours.
- Skill level:
- Moderately Challenging
Other People Are Reading
Things you need
- Wheel chocks
- Jack stands
- 3/8-inch ratchet and socket set
- Replacement carrier bearing
- Large hydraulic press
Put the wheel chocks around the front wheels on the Equinox, then lift the rear of the vehicle up using the jack. Put jack stands underneath the body.
Unbolt the driveshaft from the axle with the 3/8-inch ratchet and socket, then unbolt the other half of the driveshaft from the PTU flange on the front of the vehicle. Unbolt the carrier bearing from the chassis. Pull the driveshaft assembly out from the bottom of the Equinox. Take the driveshaft assembly over to the large hydraulic press.
Set the driveshaft into the press and use the press to remove the carrier bearing from the driveshaft. Install the replacement carrier bearing on the driveshaft with the press, then put the driveshaft assembly underneath the Equinox.
Bolt the driveshaft carrier bearing to the chassis with the 3/8-inch ratchet and socket. Bolt the driveshaft to the axle with the 3/8-inch ratchet and socket, then bolt it to the PTU flange with the 3/8-inch ratchet and socket.
Lower the Equinox off of the jack stands using the jack, then take off the wheel chocks.
- 20 of the funniest online reviews ever
- 14 Biggest lies people tell in online dating sites
- Hilarious things Google thinks you're trying to search for