How to Set Up a Kelsey Trailer Brake Controller

Written by john cagney nash
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Set Up a Kelsey Trailer Brake Controller
The correct set-up of trailer braking devices is vital to safe towing. (Jupiterimages/Photos.com/Getty Images)

Kelsey-Hayes, often called simply Kelsey, was a manufacturer of wheels and wheel braking systems. The company used to specialise in hydraulic brake control devices, but these devices are now considered unsafe and are no longer manufactured. In 2011, Kelsey currently produces in-cab electronic brake controllers, which have a similar set-up to that of any other manufacturer's controllers. The Kelsey trailer brake controller works only in 12-volt vehicles, and on single- and twin-axle trailers; it cannot operate more than four electric brakes.

Skill level:
Moderately Easy

Other People Are Reading

Things you need

  • No tools required.

Show MoreHide

Instructions

  1. 1

    Hook up a trailer to the tow vehicle and connect the round seven-pin hitch. Start the tow vehicle engine and confirm that the red control module indicator light on the front right of the unit is dimly illuminated.

  2. 2

    Drive slowly to a flat, level road surface where other road users will not be inconvenienced. Disconnect the tow hitch.

  3. 3

    Depress the brake pedal just far enough to illuminate the tow vehicle brake lights. Use a finger to pull the pendulum levelling arm -- a small lever on the left side of the unit -- toward the front of the Kelsey trailer brake controller and confirm that this makes the control module indicator light glow brightly. Push the pendulum levelling arm slowly in the opposite direction until the control module indicator light is at its dimmest. Release the brake pedal.

  4. 4

    Slide the manual actuating lever fully to the left; confirm that this action causes the control module indicator light to glow at its brightest. Release the lever.

  5. 5

    Reconnect the trailer hitch and have an assistant confirm the trailer brake lights illuminate when the manual lever is again slid fully to the left. Adjust the load control knob -- a circular handle on the right side of the unit -- to its medium setting, then accelerate to approximately 20 miles per hour.

  6. 6

    Brake the tow vehicle normally. The trailer should brake at the same pace as the tow vehicle, neither pushing forward nor dragging. Release the brake pedal and turn the load control knob clockwise to increase trailer braking, and counterclockwise to decrease trailer braking. Repeat the exercise until the setting is ideal.

  7. 7

    With the set-up complete, depress the brake lever again. Concentrate on the control module indicator light. Check that its brightness increases as the stopping force increases, so that it is at its brightest when the pedal is fully depressed.

Tips and warnings

  • Trailer brakes hum under normal use. This may be noticeable when setting up the Kelsey trailer brake controller but not when driving.
  • If trailer wheels skid, the driver may lose control. The adjustment for full deployment of the brakes must be made so that the wheels are just short of locking-up and skidding.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.