How to use a handheld rivet on an aluminum sheet

Written by michael signal
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to use a handheld rivet on an aluminum sheet
Aluminium is easier to manipuate than harder metals sich as steel. (emboutissage image by photlook from Fotolia.com)

Sheet aluminium has a high strength-to-weight ratio and is a light metal. Metal workers can manipulate it by bending, cutting and rolling it. Using handheld blind rivets, or pop rivets, is a good way to secure and attach pieces of sheet metal. Even workers or do-it-yourselfers at home can quickly become efficient at using blind rivets. They require a special tool for installation, but they don't require two people, pneumatic equipment or the specialised skill needed to work with their cousin, the solid rivet, or buck rivet.

Skill level:
Moderate

Other People Are Reading

Things you need

  • Heavy gloves
  • Aluminium sheet
  • Clamps
  • Metal shears
  • Rotary tool with cut-off, grinding and polishing wheels
  • Drill with drill bits
  • Blind rivets
  • Blind-rivet puller
  • Permanent marker
  • Ruler

Show MoreHide

Instructions

  1. 1

    Cut the aluminium to the needed size. You can use metal shears if you're working with thin sheets of aluminium. You'll want to use an electric or pneumatic rotary tool with a cut-off wheel for heavy pieces.

  2. 2

    Finish your rough edges. You may have left dangerously sharp edges after cutting your sheet metal. Install a grinding wheel on your rotary tool to remove large and especially jagged parts, and then finish the edges with a polishing wheel.

  3. 3

    Lay out your hole pattern. Use your ruler to measure your hole locations and mark them with a permanent marker.

  4. 4

    Clamp the sheet metal in place. Drill your rivet holes through every piece of material that will be riveted while the pieces are clamped securely together, if the rivets are going to be installed into new locations. If there are already rivet holes, clamp the pieces together and install your rivets.

  1. 1

    Place an appropriate rivet in a hole. It should be slightly smaller than the hole diameter and it should have a grip length equal to the total length of all the material being riveted.

  2. 2

    Position the rivet puller so that the small hole at the end of the nose fits over the protruding rivet stem.

    How to use a handheld rivet on an aluminum sheet
    A rivet puller can have interchangable heads to fit different sizes of rivets. (riveter and rivets image by Christopher Dodge from Fotolia.com)
  3. 3

    Squeeze the handle while pressing the rivet gun down to keep the rivet head flush with the metal. The stem will pull through and break off as your rivet is secured. Repeat this for every rivet.

Tips and warnings

  • You can use a pneumatic rivet puller if you have one, but a hand puller is almost always adequate.
  • Blind rivet grip length is measured in sixteenths of an inch and is indicated by the last digit of the rivet part number.
  • Wear your heavy gloves when cutting, polishing and grinding aluminium. You can take the gloves off when you are sure the sharp edges have been removed.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.