How to Lift a Toyota Corolla

Written by richard ristow
  • Share
  • Tweet
  • Share
  • Email

As a Toyota Corolla owner, there are things you can do to keep your maintenance costs down. You can change your own wipers, replace filters yourself and do your own oil changes. Some tasks, like oil and other fluid changes, will require you to get under your Corolla. There is always a real risk with accessing a car's undercarriage. Scissor, floor or bottle jacks do not ensure stability, and a Corolla can fall off a jack. However, you can safely elevate your Corolla if you use ramps or stands.

Skill level:
Moderate

Other People Are Reading

Things you need

  • Jack
  • Jack stands
  • Ramps
  • Chocks

Show MoreHide

Instructions

    Jack Stands

  1. 1

    Bring your Corolla to a full stop on level ground.

  2. 2

    Engage the emergency break. If your Corolla is an automatic, move the shifter into park. If the car has a standard transmission, shift it into reverse.

  3. 3

    Secure the wheel diagonally opposite the one you want to lift. For example, if you are raising the rear passenger's side wheel, you need chocks around the driver's side front wheel.

  4. 4

    Place your cranking jack at a proper lifting point. These points are designated in your owner's manual, usually in the section on replacing a flat tire. The Toyota Corolla has a series of notches below the front and rear doors on both sides. These are the designated lifting points. The jack needs to go into the notch nearest the wheel to be lifted.

  5. 5

    Raise the Corolla with the jack. Slide a jack stand under the frame and lower the car onto the stand. Remove the jack. Repeat the process for each wheel until you have all four wheels off the ground and securely positioned on the jack stands.

    Ramps

  1. 1

    Position ramps in front of each front wheel. Wedge the ramp between the ground and the underside of the tire.

  2. 2

    Drive the Corolla up the ramps. Do this very slowly, as you do not have a lot of room to manoeuvre on the ramps.

  3. 3

    Engage the emergency brake. Shift an automatic into park, and a standard trans into reverse. Turn the Corolla off and exit the vehicle.

  4. 4

    Block the back of each of the Corolla's tires with wheel chocks.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.