How to service power tilt and trim on Johnson outboard motors

Written by will charpentier
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to service power tilt and trim on Johnson outboard motors
Keep your outboard motor operational. (Jupiterimages/Photos.com/Getty Images)

The power trim and tilt system used on Johnson outboard motors serves two purposes. The first is to trim your boat to optimise the laminar flow between the hull and the water -- it gets up on plane faster and rides better. The second function, tilt, allows you to raise your motor for beaching, trailering or docking in salt water, when you want to prevent the accumulation of salt deposits in the raw water cooling system.

Other People Are Reading

Things you need

  • Digital multimeter
  • Hydraulic fluid

Show MoreHide

Instructions

  1. 1

    Connect the multimeter black lead to a good engine ground and check for voltage at the battery side of the starter solenoid with the red multimeter lead. Mark the "Up" and "Down" relays and remove them from the relay sockets. Connect the red multimeter lead to terminal V1 and the black lead to V2 to check the "Up" circuit.

  2. 2

    Push the tilt/trim "Up" button and check for voltage at terminal V3. Disconnect the blue/white tilt limit switch bullet connectors. Reconnect them, bypassing the tilt limit switch and repeat the previous step to test for voltage at V3 when pressing the trim/tilt up button on the lower motor cover. If voltage is present, replace the tilt limit switch.

  3. 3

    Connect the red multimeter lead to relay blade M for terminal V4 and the black lead to a good engine ground. Disconnect the blue and green wire connector from the trim motor. Check for voltage on the blue wire when the Up" button is pressed. Repeat the same test for the "Down" circuit, using terminal V7.

  4. 4

    Connect the red multimeter lead to terminal V5 and the black lead to V6. If the multimeter doesn't show 12 volts DC, check the red wire between the relay socket, the starter solenoid and the ground.

  5. 5

    Push the trim/tilt "Down" button on the lower motor cover and check for voltage at V7. Press the "Down" trim button and watch for voltage on the blade at V7.

  6. 6

    Remove the hydraulic reservoir cap. Add hydraulic oil to the reservoir until the oil is at the base of the reservoir's filler neck.

  7. 7

    Run the tilt/trim system all the way up and all the way down at least five times. Add fluid and repeat, if necessary. Recap the hydraulic reservoir and lower the tilt/trim.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.