How to winterize a seadoo gtx 4-tec

Written by thomas buchanan
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to winterize a seadoo gtx 4-tec
Once winter hits the lake, it's time to do preventive maintenance on your GTX 4-TEC. (winter image by ennavanduinen from

A day out on the water with the 155hp GTX 4-TEC from Seadoo might just well be the epitome of what a perfect summer day should be. But all good things must come to an end, and a harsh winter means it's time to put the GTX away for the season. To make sure that its ready to spring back to life as soon as those warm days start coming around again, a few hours spent winterising your jet ski is an important step.

Skill level:

Other People Are Reading

Things you need

  • Fogging oil
  • Gasoline
  • Jet ski cover
  • Lube
  • Rag
  • Wax

Show MoreHide


  1. 1

    Drain the water from your engine as soon as it is done for the season. Attach the GTX 4-TEC to your trailer as usual so that the stern is at the lowest position. Run the engine a few times for up to 30 seconds each time until water has ceased draining from the craft.

  2. 2

    Clean and thoroughly dry the exterior as well as interior of the craft. Be sure to remove any algae which may have accumulated, as it will only continue to harden and dry out over the winter and become much more difficult to manage in the spring. Once finished, this is a good opportunity to give it a light coat of wax and use a small amount of multipurpose lube on any exposed metal surfaces such as the two adjustable mirrors.

  3. 3

    Add in a fresh tank of gas. Add a small amount of gas stabiliser to prevent the fuel from becoming gummy over its months of storage. Again, start the engine and allow it to run for up to 30 seconds so that the stabiliser has the opportunity to circulate throughout the entirety of the engine.

  4. 4

    Raise the GTX 4-TEC's seat to access its engine. Remove the air cleaners before starting the engine, allowing it to idle. Spray the can of fogging oil down into the carburettors until the engine stalls. Replace the air cleaners. Remove the spark plugs and spray more fogging oil into each of their sockets. With all the spark plugs still removed, place a rag over their holes and engage the engine. Though it will not start without the spark plugs, this will allow all of the fogging oil to evenly distribute itself internally. Clean up any errant oil and replace the spark plugs.

  5. 5

    Disconnect your battery's negative terminal, and then the positive terminal. Remove it from the craft and store it in a reasonably warm, dry, elevated location such as a wooden block.

  6. 6

    Cover the craft in its cover to further protect it from dust or weather and store it in a level position over the winter.

Tips and warnings

  • Do not place your battery on concrete.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.