How to Install a Camry Flasher Assembly

Written by daniel valladares
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Install a Camry Flasher Assembly
It should take no more than five minutes to install a flasher assembly on a Toyota Camry. (Front-light of black mercedes image by Mladenov from

The Camry is a mid-sized car produced by Toyota since 1982. The indicators are some of the most essential safety components on the Camry and should be replaced if they burn out. Installing a new turn signal assembly on your Toyota Camry is fairly simple, and you only need the assembly.

Skill level:


  1. 1

    Turn the Camry's engine off and open the bonnet. Before installing the new assembly, the old one must be removed.

  2. 2

    Remove the pushpin atop the turn signal assembly. You can use your nails to pry it out, but if it is too difficult, you can use a slotted screwdriver.

  3. 3

    Press in the two tabs on the sides of the assembly. Slide the assembly out of the engine compartment. Squeeze the plastic locking tabs on the electrical connector to remove it from the assembly and remove the assembly from the vehicle.

  4. 4

    Connect the electrical connector to the new assembly, making sure it snaps into place.

  5. 5

    Slide the assembly into the engine compartment until the two tabs click, securing it to the vehicle.

  6. 6

    Reattach the pushpin to the assembly and close the bonnet.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.