How to cut angles by bay windows for laying laminate flooring

Written by paul massey
  • Share
  • Tweet
  • Share
  • Email

Installing a new laminate floor involves some basic fitting to the shape of the room. This is a fairly straightforward task along standard walls or door openings, but filling in the floor area of a bay window protrusion requires some specific angle cutting. Determining these angles and cutting them correctly is a simple procedure that will help you complete your new laminate floor's installation.

Skill level:
Moderate

Other People Are Reading

Things you need

  • Tape measure
  • Pencil
  • Bevel square
  • Protractor
  • Mitre saw, circular saw or jigsaw
  • Hammer
  • Tapping block
  • Pull bar

Show MoreHide

Instructions

  1. 1

    Determine the bay-window alcove's side angles by placing a bevel square's handle or body section against the flat surface at the base of the wall adjacent to the bay window, and then rotating the bevel square's blade until it's flat against the bay window side wall. Tighten the blade screw on the bevel square to lock the angle setting for use in marking all of the plank cuts.

  2. 2

    Align the blade of the bevel square with a protractor to determine the angle set in Step 1.

  3. 3

    Measure the beginning cut point on the first laminate flooring plank to be installed in the bay window alcove and mark the cutline on the plank's surface. Be sure to include the end-joint notch needed for the adjoining plank and allow for the typical wall spacing specified by the flooring manufacturer.

  4. 4

    Cut the first plank to the angle marked using a mitre saw, circular saw or jigsaw, and then install the plank into place using the attachment method for the flooring. Use a tapping block and hammer to tighten the flooring joints as necessary.

  5. 5

    Install the next full flooring planks or measure the plank length needed from the previous end joint to the angle cut point, whichever is appropriate.

  6. 6

    Lay out the cut angle and plank length for the next piece and mark the cutline on the plank's surface. For the bay window wall angle on the opposite side, simply reverse the bevel square to mark the angle. Cut the plank's length and end angle using a mitre saw, circular saw or jigsaw, and then install the plank into place using the attachment method for the flooring. Use a tapping block and hammer to tighten the flooring joints as necessary.

  7. 7

    Mark the side wall angle on the starting plank of the next row of laminate flooring boards using the bevel square setting. Cut the plank and install it in place, and then install the rest of the row of planks, cutting the end plank with the angle determined in Step 1.

  8. 8

    Repeat Step 7 to complete the flooring planks within the bay window alcove.

Tips and warnings

  • You can't use a tapping block for the final row of flooring planks in the bay window alcove. You will need a pull bar to snap the side and end joints into the preceding row of planks.
  • Be certain to include the laminate flooring manufacturer's suggested wall spacing in the cutting measurements of the flooring pieces.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.