How to winterise the MerCruiser 4.3L V6

Written by jared curtis
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to winterise the MerCruiser 4.3L V6
The MerCruiser engine needs proper care before winter storage. (propeller image by Gonçalo Carreira from

You must winterise your MerCruiser 4.3L V6 before storing it. The engine sucks water up from the lake through the impeller to cool the engine. This water does not automatically drain out of the engine. Because water expands when it freezes, it's imperative to drain the water from the engine. The carburettor also needs special attention. To reduce the risk of costly repairs, winterise your boat properly.

Other People Are Reading

Things you need

  • Fuel stabiliser
  • Open-end spanner
  • Garden hose with water supply
  • Motor flush tool
  • Fogging oil

Show MoreHide


  1. 1

    Open the fuel tank cap and add the appropriate amount of fuel stabiliser into the fuel tank. Refer to the label on the bottle for the proper amount.

  2. 2

    Remove the boat drain plug with an open-end spanner. It is located at the bottom-rear of the boat.

  3. 3

    Open the engine compartment and remove the nut holding the spark arrester on the carburettor using an open end wrench. The spark arrester is a round, metal air filter.

  4. 4

    Attach a garden hose to the motor flush tool and place it over the vents on the out drive. Turn the water supply on and allow the air bubbles to work out of the hose before starting the engine.

  5. 5

    Start the engine and allow it to run for five minutes.

  6. 6

    Spray fogging oil in and around the carburettor until the engine dies out. This will keep the carburettor clean during the winter.

  7. 7

    Turn off the water supply and remove the motor flush tool from the out drive.

  8. 8

    Remove the drain plugs on the bottom of the engine block using an open-end wrench. Refer to your owner's manual for drain plug location, as it varies depending on the year of manufacture. Allow the water to drain from the block completely. Reinstall the drain plugs and tighten them using a spanner.

  9. 9

    Lower the out drive as far to the ground as possible without hitting it by pressing the button on the throttle assembly. This will keep the gears in the out drive lubricated throughout the winter.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.