How to flash a chimney pipe on a corrugated steel roof

Written by mona culberson
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to flash a chimney pipe on a corrugated steel roof
Rubber boots are easy to install around chimney pipes. (abstract red metal tiled roof background and chimney image by Avesun from

Chimney pipes on metal roofs must be flashed in order to create a watertight seal around the pipe and prevent leaks through the roof. The flashing can be installed quickly and easily with kits that use rubber pipe boots. The rubber boot is trimmed to fit around the pipe and then secured to the roof with screws and sealant. Rubber boot kits can be purchased online or at a roofing supply store for about £10 ($15). Installation takes about 15 minutes.

Skill level:
Moderately Easy

Other People Are Reading

Things you need

  • Roofing knife
  • Pencil
  • Caulking gun
  • Roof sealant
  • Sheet-metal screws
  • Drill
  • Rubber boot kit

Show MoreHide


  1. 1

    Trim the flashing in the centre of the rubber boot with a roofing knife so it fits snugly around the pipe. Slide the rubber boot over the pipe to check the fit. Trace the outline of the base of the rubber boot onto the metal roof with a pencil. Remove the rubber boot.

  2. 2

    Apply a generous bead of roofing sealant around the base of the pipe with the caulking gun. Add a bead of sealant on the traced line on the roof.

  3. 3

    Slide the rubber boot over the pipe. Press firmly to seal.

  4. 4

    Use the drill to secure the rubber boot flashing to the roof with 50 mm (2 inch) sheet-metal screws at 25 mm (1 inch) intervals.

  5. 5

    Apply a bead of roofing sealant around the top and base of the rubber boot.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.