How to Build a Faux Stone Pillar

Written by nicole byerly
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Build a Faux Stone Pillar
Faux stone pillars can be created easily using foam. (Old Granite Pillar image by Van Ness from Fotolia.com)

Stone pillars are a popular option for gates and entrances because they make a bold introductory statement for those entering a location. Stone pillars can be very expensive to purchase and extremely heavy to transport. Creating a faux stone pillar can be done in a short amount of time, at a fraction of the cost. The resulting pillar can still convey the natural beauty of a real stone pillar. Faux stone pillars allow a decorator to build a tower that appears to be real stone to fit in any decor.

Skill level:
Moderate

Other People Are Reading

Things you need

  • 2 4x8-foot foam insulation board, 1-inch thick
  • Large straight edge
  • Utility knife
  • Tape measure
  • Hot wire foam shaper
  • Textured white paint
  • Textured grey paint
  • Textured dark red paint
  • Textured black paint
  • Paint brush
  • Gorilla glue
  • 2 5-foot small ropes
  • Exacto knife
  • Scissors
  • Black fine point marker

Show MoreHide

Instructions

  1. 1

    Mark each of two 4-by-8-foot sheets of foam into eight 1-by-4-foot strips. Cut each 1-inch-thick sheet using a utility knife against the straight edge.

  2. 2

    Glue the 16 strips together with gorilla glue. Lay one 1-foot-by-4-foot strip on a flat surface. Cover the top with gorilla glue. Press the second strip of foam on top, lining up the edges. Continue to apply glue and stack layers of foam until all 16 strips are piled on top of one another.

  3. 3

    Place the foam in a standing position so it is 4 feet high. Wrap a 5-foot length of small rope loosely approximately 12 inches from each end. Allow glue to dry completely before continuing.

  4. 4

    Measure and mark 4 inches from the top of the foam tower with a fine-point marker. Place a straight edge along the 4-inch mark and draw a straight line around the entire tower.

  5. 5

    Draw stone patterns on the four exterior sides of the tower below the 4-inch mark.

  6. 6

    Heat up a hot wire foam shaper, and gently press it into the drawn-on stone pattern. Move the foam shaper around gradually to form the stone texture in the pillars. Trace the drawn-on line with the foam shaper to create a concrete top on the pillar.

  7. 7

    Paint the faux concrete top using textured grey paint. Fill in all of the lines between the foam stones with the grey paint.

  8. 8

    Paint stones different colours to create a more realistic appearance.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.