Store-bought table number holders can be expensive, even though they are inexpensive for manufacturers to make. Make your own place card or table number holders and save on the budget for your event. You can make customised and decorative place card holders with little more than wire stock and you can make them in any shape you like. Make a number holder for each table at your event and reuse them for any other event you plan--to hold numbers, names or even menu cards.
- Skill level:
Other People Are Reading
Things you need
- 12 inches of 20 gauge wire stock for each holder
- Wire cutters
- Needle-nosed pliers
- Table number cards
Cut your wire stock into 12 inch sections with your wire cutters. Each section of wire will create one number holder.
Pinch the end of one 12 inch section with your needle-nosed pliers.
Grasp the free end of the wire with your free hand and turn the needle-nosed pliers to bend a 2 inch wide circle. This will be the base of your number holder.
Bend the remaining length of wire toward the centre of the circle and pull the wire upward so that you have a circular base with a straight section of wire sticking straight up out of the middle.
Grip the very end of the straight wire with your pliers and bend it into a simple coil, or even a heart-shaped coil. When you are coiling the wire, grasp the pliers tightly and pull it to shape the wire. Make at least two layers of the coil so that the card can rest between them.
Tips and warnings
- Slide beads onto the wire before you start shaping it, if you want to add some colour.