How to recharge freon to repair a refrigerator

Written by robert sylvus
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to recharge freon to repair a refrigerator
Refrigerators use Freon to stay cold. (réfrigérateur image by dead_account from

Freon, Dupont's trademarked name for CFC and HCFC refrigerants, has become a generic name for all refrigerants. Refrigerators manufactured before 1995 usually contained R-12, a CFC, as a refrigerant. Only EPA certified technicians can buy R-12. Refrigerators manufactured from 1995 to the present typically use R-134a, an HFC, as a refrigerant. Both refrigerators and automobiles use R-134a as a refrigerant, and adults can buy it at most automobile parts stores. Combining the noncompatible refrigerants R-12 and R134a will lock up the compressor.

Skill level:

Other People Are Reading

Things you need

  • Phillips screwdriver
  • Nut driver
  • Saddle valve kit
  • Refrigerant valve adaptor
  • Refrigerant charging hose kit

Show MoreHide


  1. 1

    Remove the compressor access cover from the rear of the refrigerator. Use a Philips screwdriver or a nut driver to remove the screws.

  2. 2

    Look at the tag found on the compressor for the type of refrigerant used.

  3. 3

    Install a saddle valve on the large copper pipe coming from the compressor. A saddle valve pierces the refrigerant line for access. A saddle valve uses two pieces to wrap around the pipe with hex-head screws holding them together. Use the hex-head wrench that comes with the valve assembly to tighten the hex-head screws.

  4. 4

    Install a refrigerant valve adaptor to the saddle valve. The adaptor screws onto the saddle valve service port.

  5. 5

    Connect a refrigerant charging hose kit to a can of refrigerant. The charging hose kit includes a colour-coded gauge, hose, threaded fitting that connects to the can of refrigerant, and a service valve connection that will connect to the adaptor on the saddle valve.

  6. 6

    Connect the charging hose connection to the saddle valve adaptor. This snaps into place.

  7. 7

    Use the hex-head wrench to turn the piercing valve, found in the centre of the top half of the saddle valve, three full turns. Back the wrench out one full turn. Residual refrigerant from the refridgerator should enter the charging hose.

  8. 8

    Turn on the refrigerator. Allow it to run until the pressure gauge stops dropping. This usually takes three to five minutes.

  9. 9

    Check the pressure gauge. R-134a ideally should have between 25 and 45 psi. Open the refrigerant can port, allowing refrigerant to enter the system. Close the port every minute to check the pressure. Continue to add refrigerant until the pressure has reached the correct range.

  10. 10

    Close the piercing valve with the hex-head wrench. Disconnect the charging hose. Reinstall the compressor access cover.

Tips and warnings

  • The refrigerator lines and coils must not have frost covering them when recharging with Freon.
  • When charging the system, you can tilt the can to its side for 10 to 15 second bursts. When you do this, you must allow the system pressure to equalise before continuing.
  • Never back the saddle valve out more than one full turn.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.