How to Refinish Tongue & Groove Paneling

Written by lisa east hunter
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Refinish Tongue & Groove Paneling
Raw wood panelling (wood image by Alison Bowden from Fotolia.com)

The tongue and groove panelling in your home might be due for a makeover. Perhaps the stain is too dark, or not dark enough. Maybe you are dreaming of lightening up the whole space by giving it a coat of whitewash. Tongue and groove panelling is a significant investment in your home and one that should be well maintained and preserved. Keeping a protective stain on top of the wood will protect it from warps and stains. Removing the old stain is a labour-intensive chore, but your fresher, brighter wood panelling might just become your favourite part of your home.

Skill level:
Moderately Challenging

Other People Are Reading

Things you need

  • Paint stripper
  • Paint brush
  • Scraper
  • Palm sander
  • Sandpaper
  • Steel wool
  • Stain or whitewash
  • Rags

Show MoreHide

Instructions

  1. 1

    Spread a thick coat of chemical paint stripper on the panelling. Work in small, manageable chunks, no more than a 6-foot-wide area at a time. Allow the paint stripper to penetrate the original paint or stain, which usually takes 20 to 30 minutes. Test to see if the stain is softening by trying to remove the stain with a putty knife. When the stain removes easily, the paint thinner has done its job.

  2. 2

    Use a putty knife to remove the chemical paint thinner and the stain from the panels. Wipe the residue on the side of a bucket or a spare rag as you work. Remove as much stain from the walls as you can with the putty knife. Repeat the process with the rest of the panelling.

  3. 3

    Use steel wool to work on stubborn patches of stain. Apply the paint thinner directly onto the steel wool and work over the stain in a circular motion until the stain is removed.

  4. 4

    Sand the panelling using a palm sander, which is available at most home improvement stores for about £19. Because of its vibration, the palm sander will provide a more consistent surface than hand sanding. It also will get the job done a lot quicker. Wipe away sanding dust with a damp rag.

  5. 5

    Apply new stain. Dip a brush into the gel or liquid stain, both of which provide similar results. Brush the stain onto the wall and wipe away any excess with a clean rag. Continue this process until you have covered the entire space and have achieved a depth of colour that you like.

Tips and warnings

  • Refinishing the tongue and groove panelling on your walls will be a big job. Before you proceed, make sure that your panelling is worth all of the effort. It should be in good condition without warping or water damage. Ask a contractor to give you a quote on replacement or removal of the panelling before you go to the effort of sanding off the original finish. You might find that it would be easier to replace the panelling in lieu of refinishing.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.