How to Replace a CV Joint in a Hyundai Elantra

Written by shayrgo barazi
  • Share
  • Tweet
  • Share
  • Email

Constant velocity (CV) joints, or drive axles, allow power in your Hyundai Elantra to transfer from the transmission to the wheels while the vehicle is turning. The CV joint wears out over several thousand miles of use and makes a distinct clicking noise when the CV joint has failed. You can hear the clicking sound when turning right or left, which indicates that you should replace the CV joint.

Skill level:
Moderate

Other People Are Reading

Things you need

  • Screwdriver
  • Ratchet
  • Sockets
  • Long breaker bar
  • Jack
  • Jack stands
  • Lug nut wrench
  • Needle-nose pliers
  • Ball joint separator
  • Hammer
  • Pry bar
  • CV joint (drive axle)
  • Torque wrench

Show MoreHide

Instructions

  1. 1

    Remove the hubcap from the wheel by prying it off with a screwdriver at the edge.

  2. 2

    Remove the axle nut from the axle with a 32mm socket and a long breaker bar. The axle nut is held on at about 120 foot-pounds and will require a substantial amount of force to remove it. The longer the breaker bar, the easier it will be to remove.

  3. 3

    Jack up the Elantra and place it on jack stands.

  4. 4

    Remove the wheels, using a lug nut wrench.

  5. 5

    Remove the castle nut from the bottom of the ball joint with a ratchet; but first remove the cottar pin from the castle nut, using needle-nose pliers.

  6. 6

    Separate the steering knuckle from the lower control arm with a ball joint separator. Place the ball joint separator between the lower control arm and the steering knuckle, and use a hammer to hit the end of the ball joint separator until the ball joint breaks free. Alternatively, use a hammer to hit the side of the lower control arm where the ball joint fits into it; the ball joint will break free.

  7. 7

    Pull the steering knuckle toward you, and remove the CV joint from it.

  8. 8

    Pry between the transmission case and the CV joint with a pry bar until the CV joint breaks free. Pull the CV joint out of the Elantra.

  9. 9

    Place the new CV joint into the transmission and route it through the steering knuckle.

  10. 10

    Place a new pin into the axle, and line it up with the transmission stub that the axle fits onto. Hammer the pin into the groove.

  11. 11

    Tighten the axle nut with a ratchet.

  12. 12

    Place the ball joint through the lower control arm, and tighten the castle nut with a ratchet. Then place the cottar pin through the nut.

  13. 13

    Reinstall the wheel, and lower the Elantra.

  14. 14

    Tighten the axle nut to 120 foot-pounds with a torque wrench.

  15. 15

    Reinstall the hubcap.

Tips and warnings

  • If you don't have a breaker bar, use a 1.5-inch-diameter steel pipe approximately 6 feet in length to remove the axle nut. Place the steel pipe over a long ratchet and loosen the nut; it will come off easily.
  • Wear safety glasses to protect your eyes from injury.

Don't Miss

Resources

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.