How to Build Your Own Portable Ballet Bar

Written by dialogue queen
  • Share
  • Tweet
  • Share
  • Pin
  • Email
How to Build Your Own Portable Ballet Bar
. (nikoladesign/iStock/Getty Images)

Ballet is a demanding art form and takes years and years of practice. Every dancer needs to work on basic technique and balance on a daily basis. Having a ballet barre to work with will help a dancer improve her skills and keep up her technique. Ballet barres are quite expensive, but you can make your own for under £13.

Other People Are Reading

Things you need

  • PVC pipe
  • Pipe glue
  • Pipe cutters
  • Measuring tape
  • Rubber end caps
  • Sander
  • Drill

Show MoreHide


  1. 1

    Get out your measuring tape. Have the dancer lift her leg about 6 inches above hip level and take this measurement. This is the height for the ballet barre. Purchase some PVC pipes; get two sticks the height of the barre and two 4-foot-long pipes.

  2. 2

    Cut one of the 4-foot pipes in half. Then cut off two 3-inch sections off each end. You should now have four 3-inch pipes and two 1½-foot pipes. Place rubber end caps on one end of each 3-inch pipe.

  3. 3

    Take the 1½-foot-long pipe and drill two holes about 3 inches in from the outer edge. Make the hole wide enough for the 3-inch pipe section to fit into. Repeat with the other 1½-foot-long pipe. Then drill another hole of the same width on the top of the pipe (opposite side of the other two holes) in the centre. Repeat with the other pipe.

  4. 4

    Line each hole with pipe glue. Stick the small 3-inch pipes into the 1½-foot pipe. Hold in place until it dries. You may need to line the outer edges of the pipe with more glue to ensure it sticks. Repeat with the other side. Then line the top hole with glue and stick the pipe that is the height of the barre into it, and hold until dry.

  5. 5

    Take the 4-foot-long pipe and place it over the edges of the two standalone sections. Mark where the holes need to hit and then drill them. Line the holes and fit the pipe in; hold until dry. Sand the edges of the cut pipe sections so they are smooth.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.