How to Install a TV Antenna in the Attic

Written by nichole liandi
  • Share
  • Tweet
  • Share
  • Email

Whether for aesthetic reasons or for practical reasons, you may find it necessary to mount a TV antenna in your attic. Given the right conditions and mounting, this can work almost as effectively as mounting the antenna on the outside of the house on a mast.

Skill level:
Moderate

Other People Are Reading

Things you need

  • TV antenna
  • Coaxial cable

Show MoreHide

Instructions

  1. 1

    Determine the placement of your antenna. Place the antenna in the attic location that provides the best signal reception. Take the antenna and a TV to the attic, connect them with a short length of coaxial cable, and test different locations and aiming directions to determine the best location. Check for all the over-the-air channels you'll be planning on receiving with your attic-mounted antenna. Make marks or other indications so that you can replicate the location when it's time to mount the antenna.

  2. 2

    Mount the antenna. Depending on where you've determined to mount the antenna, you may choose from a variety of different mounting methods. However you choose to secure the antenna, mount it with sturdy hardware so that the position will not shift. Most commercial television antennas come with mounting hardware. Use this, or supplement if necessary with hardware from your local hardware store. Mounting the antenna so that it is suspended from a pole secured to the rafters is an excellent way to make sure that the antenna is free from obstacles or interference and will remain in position without shifting.

  3. 3

    Determine your cable run. Since you're in the attic, it's best to run the cable down the outside of the house and then patch into any existing television cable in your residence. Secure the cable every few feet with cable clamps to ensure it won't come loose from the effects of weather and time. Ground the cable and antenna with a lightning arrester--consult your antenna's manual for more information if necessary.

  4. 4

    Connect the cable into your existing cable runs with a cable connector, adaptor or splitter. Higher quality connectors and splitters will give the best performance and are more resistant to weather, if your connection is outside. If you have connected more than one TV to the antenna cabling, be sure that you're getting good performance from all of the TVs. If not, work back along the cable runs to isolate where the problem may lie, then correct it and test again.

  5. 5

    Test your antenna by tuning in your local channels on your TV. Make any adjustments to the antenna positioning at this time if necessary to fine-tune the signal. Ensure that the antenna mounting hardware is securely fastened, and that your cable is mounted with enough cable clamps to ensure that it will not come loose.

Tips and warnings

  • Use RG-8 cable for the best picture quality, particularly for long cable runs. If the cable goes outside, be sure it is rated for outside use.
  • Always ground the cable for lightning protection.

Don't Miss

Filter:
  • All types
  • Articles
  • Slideshows
  • Videos
Sort:
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the eHow.co.uk site, you consent to the use of cookies. For more information, please see our Cookie policy.