How to calculate rafter angles

Written by eric mains
  • Share
  • Tweet
  • Share
  • Email

Determining the pitch of a roof for new construction is simple. The contractor consults the blueprints and finds the pitch, usually given as vertical rise in inches over horizontal run in inches, and then converts this ratio into a degree measurement for the guys running the mitre saw. When you get into remodelling, finding the correct rafter angles can be a little trickier, but with the right tools, calculating the rafter angles for your ceiling is a snap. Here is how to measure the angles on pre-existing rafters, so you can cut new rafters to the proper angle.

Skill level:

Other People Are Reading

Things you need

  • Rafter Angle Square
  • Level
  • Pencil
  • Scratch Paper

Show MoreHide


  1. 1

    Scribe a vertical line on a pre-existing rafter. Use the level to make sure the line is completely vertical and not canted off to either side. Any error you make with the line will be compounded when you take the angle for the rafter.

  2. 2

    Place the pivot point of a rafter angle square on the bottom edge of the rafter. Place the pivot point at the exact place where the vertical line you made crosses the bottom edge of the rafter.

  3. 3

    Align the ruler edge of the rafter angle square with the vertical line. A rafter angle square has two gradated edges. The first edge is set at a right angle to the flanged base of the rafter angle square, and is marked with a short ruler. The second edge is the hypotenuse of a right triangle and is marked with a degree scale.

  4. 4

    Observe where the bottom edge of the rafter crosses the degree scale edge of the rafter angle square. Most rafter angle squares also have a slot cut parallel to the degree scale which displays the vertical rise in inches. This is usually marked on either side to accommodate common top cuts and hip-valley cuts. For example, a degree measurement of 30 degrees corresponds approximately to a vertical rise of seven for common cuts or a vertical rise of 10 for hip-valley cuts.

  5. 5

    Note the degree measurement. Set your mitre saw to that angle and let it rip.

Tips and warnings

  • Always double check measurements before cutting a test piece.
  • Always dry fit a test piece to ensure proper angle before cutting a bunch of rafters.

Don't Miss

  • All types
  • Articles
  • Slideshows
  • Videos
  • Most relevant
  • Most popular
  • Most recent

No articles available

No slideshows available

No videos available

By using the site, you consent to the use of cookies. For more information, please see our Cookie policy.